Advertisement
Slotted Screwdriver, Adjustable Pliers,
Plumber's Putty, Electrical Tape
Phillips Screwdriver, Drain Auger, 3/8" Electrical
Clamp Connector, Wire Nuts (2), Second 1 1/2" Drain
Trap, Hammer, Hacksaw, Water Hose Clamp, Pipe
Wrench, Copper Ground Wire, Dishwasher Drain
Connection Kit, Air Gap, Electrical On/Off Switch,
Drain Tube Extension
A: Stopper
B: Sink Flange
C: Fiber Gasket
D: Backup Ring
E: Mounting Ring
F: Screws (3)
G: Snap Ring
potential hazards or unsafe practices which could
result in serious personal injury or death.
hazards or unsafe practices which may result in
minor personal injury or property damage.
www.insinkerator.com
H: Mounting Gasket/Splash Baffle
I: Lower Mounting Ring
J: Dishwasher Inlet
K: Discharge Outlet
L: Wrenchette
M:Removeable Sound Baffle
The warning symbol alerts you to
The caution symbol alerts you to
Read through the entire Installation, Care & Use
manual before installing the disposer. Determine which of the
tools, materials, and accessories you will need before you begin.
Make sure you have all necessary disposer parts before installing
the disposer.Read through the entire Installation, Care & Use
manual before installing the disposer. Determine which of the
tools, materials, and accessories you will need before you begin.
Make sure you have all necessary disposer parts before installing
the disposer.
H
(optional)
#1
OR
#2
Discharge Assembly #1
N: Nut
O: Beveled Discharge Tube
(1-1/2" Diam.)
P: Beveled Washer
Q: Flanged Gasket
OR
Discharge Assembly #2
O: Discharge Tube/Gasket
(1-1/2" Diam.)
R: Flange
S: Screw
Advertisement
Table of Contents
Related Manuals for InSinkErator Food Waste Disposer
Summary of Contents for InSinkErator Food Waste Disposer
- Page 1 The warning symbol alerts you to potential hazards or unsafe practices which could result in serious personal injury or death. The caution symbol alerts you to hazards or unsafe practices which may result in minor personal injury or property damage. www.insinkerator.com...
-
Page 2: Install Flange In Sink Hole
CHECK INSTALLATION DIMENSIONS A: Disposer Height " 8 " 6 " 4 " 2 " 4 B: Distance from bottom of sink bowl to centerline of discharge " 4 " 4 " 2 " 4 " 6 outlet. (Add 1/2” when stainless steel sink is used.) "... -
Page 3: Remove Existing Disposer
REMOVE EXISTING DISPOSER 1. Turn off electrical power at fuse box or circuit breaker. Electric Shock • Turn off electrical power at fuse box or circuit breaker before removing electrical cover plate. • Disposer must be grounded. Improper connection can result in electric shock. -
Page 4: Connect Disposer To Electrical Supply
CONNECT DISPOSER TO ELECTRICAL SUPPLY Electric Shock • If you are not thoroughly familiar with electric • All wiring must comply with local electrical power, contact a qualified electrician to codes. connect disposer to electrical circuit. • Do not attach ground wire to gas supply pipe. •... -
Page 5: Connect Disposer To Mounting Assembly
CONNECT DISPOSER TO MOUNTING ASSEMBLY Clear any objects from inside the disposer grind chamber before mounting the disposer to the sink. 1. Position disposer with three mounting tabs (A) aligned in position to slide over mounting tracks (B) (see Figure 10-1). 2. -
Page 6: Operating Instructions
• To reduce risk of injury, supervise operation in presence of children. • When attempting to loosen a jam in the food waste disposer, use a self service wrenchette as described below. Use long-handled tongs or pliers to remove objects from disposer. - Page 7 This warranty covers all replacement parts and repair labor to correct defects in disposer material and workmanship for the full warranty period from the date of installation in your home. If warranty service is required during the warranty period, contact an authorized In-Sink-Erator® service center to replace or repair the unit in your home at no cost to you.
Need help?
Do you have a question about the Food Waste Disposer and is the answer not in the manual?
Questions and answers