Adjusting The Mower Deck; Leveling; Cutting Height - Dixon Mower Operator's Manual

Adjusting the Mower Deck

WARNING!
Before performing any service or adjustment checklist:
1. Engage the parking brake.
2. Place the Blade switch in the disengaged position.
3. Turn ignition switch to "OFF" position and remove the key.
4. Make sure the blades and all moving parts have completely stopped.
5. Disconnect the spark plug wire from all spark plugs and place the wire where it cannot
come in contact with the plug.
Check the tire pressure before adjustment of the
mower deck. See "Checking Tire Pressure" in
Maintenance section. Faulty mower deck adjustments
will cause an uneven mowing result.

Leveling

Adjust the deck while the mower is on a level surface.
Make sure the tires are inflated to the correct pressure.
See "Technical Data" under Transmission. If tires are
under or over inflated, you cannot properly adjust your
deck.
Four slots control the height and pitch of the mower
deck. The deck should be adjusted slightly higher in
the rear.
NOTE:To insure accuracy of leveling procedure,
mower deck drive belt must be installed prior to
leveling deck.
1. Wear heavy gloves. Turn each outer blade tip to
align with the deck or in a side-to-side manner.
2. Measure from the floor surface up to the bottom
of the blade tip on the discharge side of the
mower deck. Retain this measurement. Move to
the opposite side, check that measurement is the
same. If adjustment is required, loosen the locknut
and move mounting bolt up or down in slot until
both side-to-side measurements are equal. Retain
measurement.
3. Turn both outer blades to align with the deck in
front-to-rear manner. Reposition rear mounting
bolts up or down until rear of mower deck is
positioned level to /
1
side-to-side measurement.
NOTE: This will place the mower deck in a base
measurement position. Additional adjustment may be
required to achieve desired cut for the type of grass or
conditions being mowed.
44
-Dixon
MAINTENANCE
" higher in the rear than the
8
WARNING!
Blades are sharp. Protect your hands
with gloves and/or wrap blades with
a heavy cloth when handling.
3
1. Front lift arm
2. Chain
3. Rear lift arm
4. Slotted deck hanger plates
Leveling the mower deck
2
1
4
8011-601-3