Fishfinder; Seatalk Hs Switch Led Indications - Raymarine G-Series system Installation & Commissioning Instructions

Fishfinder

• Problem
• No data source for the fishfinder.
• Invalid custom configuration message
9.2 Status LEDs
hs
SeaTalk Switch LED indications
LED State (Connected channels only)
• For all connected channels:
1 steady and 1 flashing green LED.
• No LEDs are illuminated
• Some LEDs are not illuminated
G-Series Installation & Commissioning
• Possible cause / solution
• DSM power supply fault.
• Other DSM fault.
hs
• SeaTalk network problem.
• Software mismatch between equipment may
prevent communication.
• Indicates an invalid manual override of switch
settings at the transducer
Causes
• No problem detected
• No power to SeaTalk
• Cable / connection faults on the channels with non-illuminated LEDs.
• Equipment connected to non-illuminated LEDs may be faulty.
98
• Possible solutions
• Check the DMS power supply.
Refer to troubleshooting
• Refer to the instructions supplied with the DSM unit.
• Check that the DSM is correctly connected to the
hs
SeaTalk switch.
• Check the status of the SeaTalk
Refer to troubleshooting
• Check that SeaTalk
• Contact Raymarine technical support
• Refer to your DSM and Transducer documentation for
further information
(Steady LED indicates network connection
Flashing LED indicates network traffic)
hs
switch
Power up on page 92.
hs
Switch.
Status LEDs on page 98.
hs
cables are free from damage.