Connecting To Tv And Additional Components - GE GTD120 User Manual

Connecting to TV and additional components

• Use the supplied audio cables to connect AUX 1
jacks to the corresponding audio output jacks on the
TV, VCR or other audio/visual components.
• Connect the S-VIDEO OUT jack to the S-Video input
jack on the TV using a S-Video cable. (Not included)
• Connect the VIDEO OUT jack to the Video input
jacks on the TV using a video cable.
TV
S-VIDEO OUT
480I
S-VIDEO
480P
P-SCAN
You may use this output selector to
select your desired output signal.
Output signal selection
S-video
S-video provides a better connection for the video signal than composite video (yellow color terminal).
Component video output
Component video terminal provides the best connection for video. By separating the color information (Pb/Pr) and the
luminance signal (Y), the image is improved compared to using S-video or composite video connection (result may vary on
different TV / monitor). If your TV is equipped with these terminals (e.g. Y/Pb/Pr, Y/Cb/Cr, Y/B-Y/R-Y), use an appropriate
video cable (75 Ohm) and connect to the system. Make sure to match the terminal color.
Setup Video output
You can select either S-video, component and component (with progressive scan function) as your video output.
When S-video output is selected, only S-video and composite output will function properly.
When 480I output is selected, the component output will only deliver 480i signal.
When 480P P.Scan output is selected, the component output will only deliver 480p signal.
Progressive Scan
Progressive scan function can only be activated when 480P P.SCAN output is selected.
Warning: Make sure your TV is compatible with progressive scan function before switching the output selector to 480p
P.scan position (see TV instruction manual for details), otherwise no image will be displayed on the TV.
Pr
Pb L
R
Y
IN IN
COMPONENT VIDEO
AUX 1 AUX 2
OUT(480P/480I)
Connections
• Connect the AUX2 jack to any audio/video device
using Audio/Video cables
• Connect the YPbPr OUT jack to the TV with corre-
sponding input (if available).
VCR
TV with RF input only may need a RF modulator
(not included) for inputting audio / video signals.
The diagram shown above may varies from your actual RF
modulator, please refer to your RF modulator manual.
SAT
TV
RF cable
RF in RF out
RF modulator
AV in
AV cable
AV out
ON/STANDBY
DVD player
EN
7