Important Safety Instructions Dear SunBriteTV Customer: Congratulations on your ownership of the SunBriteTV Model 5510HD. This product is designed as a weatherproof LCD television that can be installed outdoors. To ensure safety and minimize mechanical malfunctions of your product, please read the Important Safety Instructions carefully before using this product.
Page 3
When the TV is not in use, it is important to keep it covered with the SunBriteTV fitted Outdoor Dust Cover. Use a soft brush or towel to remove snow and ice from the TV. In areas where dust or salt air is prevalent, it is recommended that the fiber filter be cleaned regularly (see instructions in Care section).
Page 4
However, it is not designed to withstand pressure washers, high-pressure water jets, or hurricane-type weather. Do not service sunBriteTV yourself: Removal of the television screen cover may expose you to high voltage or other dangerous risks. Refer all servicing to a qualified service professional. Warranty will not be honored if you service the unit yourself.
Features Information and Instructions Internal Thermostatically-Controlled Heater Programming Other Manufacturers’ Universal Remote Control Devices SunBriteTV Pixel Quality Policy Appendix A - RS232 Control Codes Appendix B - RS232 Control Cable Pinout SunBriteTV Model 5510HD Operator’s Manual Page 5 Page 5...
Supplied Accessories Unpacking After unpacking the SunBriteTV television, please make sure that the following items are included in the carton and that they are in good condition. If items are damaged or missing, contact your dealer immediately. SunBriteTV LCD Television Model 5510HD Remote Control with Batteries Operator’s Manual...
Speaker Cable Wire should not be placed across the bottom of the Rubber Sealing Gasket (Figure 6). Figure 6 Figure 4 Figure 5 Speaker Connector Thumb Screws Connect Source Cover Rubber Sealing Gasket Speaker Cable Speaker Cable Wire should not come out of this area SunBriteTV Model 5510HD Operator’s Manual Page 7...
(See Appendix A of this manual for a list of RS232 control commands and Appendix B for a Control Cable Pinout Diagram.) 14. 12 VDC: This port is for the SunBriteTV FM Figure 3 Radio (Item SB-FM 461) connector only.
RS232 control commands and Appendix B for a Control Cable Pinout Diagram.) 15. 12 VDC - This port is for the SunBriteTV FM Radio connector only. Emitter Window: Figure 15 shows an Emitter* installed. One end of the Emitter is to be mounted in IR Emitter placed over the IR Window front of the IR Emitter Window.
Page 10
TV Installation – Rear Panel Connections Cable Descriptions: Connection Descriptions: Blue Green Yellow Green White Page 10...
Page 11
COnneCTing TO an anTenna Connecting to Digital Cable without Cable Box or Antenna: Note: For ease of install, SunBriteTV has included a Push-on Coaxial Adapter. 1. Make sure the power to the TV is turned off. 2-a. Connect the Coaxial RF cable from your antenna...
Page 12
TV Installation – Rear Panel Connection Diagrams COnneCTing TO a DVD Player Connecting with HDmi (Best) Connecting with Component (Better) 1. Make sure the power of TV and your DVD player is turned off. 1. Make sure the power of the TV and your DVD player is turned off.
Page 13
DVD player and Composite’s white connector port off the back of your TV. connector port off the back of your MODEL 5510HD. Connect the red color connector to both your DVD player Connect the red color connector to both your DVD player and Composite’s red connector port off the back of your TV.
Page 14
TV Installation – Rear Panel Connection Diagrams Connecting with COnneCTing TO a saTelliTe Or CaBle seT-TOP BOX Component (Better) Connecting with HDmi (Best) Make sure the power of the TV and your set-top box is Make sure the power of TV and your set-top box is turned off. turned off.
Page 15
DVD player and Composite’s white connector port off the back of your TV. connector port off the back of your MODEL 5510HD. Connect the red color connector to both your DVD player Connect the red color connector to both your DVD player and Composite’s red connector port off the back of your TV.
Page 16
TV Installation – Rear Panel Connection Diagrams COnneCTing TO an eXTernal amPliFier Or amPliFieD sPeaKers Connecting with sPDiF Digital (Best) Connecting with rCa audio analog (good) 1. Make sure the power of the TV and your receiver is turned 1. Make sure the power of the TV and your receiver is turned off. off.
In OSD menu, both keys are used to navigate within the menu. Adjusts volume. Vol+ /Vol- In OSD menu, both keys are used to navigate within menu. Vol+ is used to select the highlighted options. Front Panel IR Sensor SunBriteTV Model 5510HD Operator’s Manual Page 17...
Remote Control Guide ON – Powers the TV On. OFF – Powers the TV Off. 0~9 – Sets the channels. Dash (-) – Inserts the dash for selecting digital channels directly. R – Returns to the previous channel. FREEZE – Freezes the TV picture. CC – Cycles between different closed captioning modes.
Page 19
The functionality of the remote control is under warranty for one year. If the remote control malfunctions within the one-year warranty period, replace the batteries with new long-life alkaline batteries. If the problem is not solved with new batteries, contact the SunBriteTV Customer Support Team. SunBriteTV will repair or replace the remote control at SunBriteTV’s option.
Initial TV Setup initial setup When the TV is turned on, you may be presented with an Initial Setup screen that will allow you to select your Language, Country and Channel Tuner scan. (In the event the Initial Set-up screen is not presented when you turn on the TV, you can manually chose these options. To set the Language screen, Press the Menu button and scroll to the OSD Language.
The Channel Menu is available only when the Digital TV or Analog TV source is selected. (Using the source button, choose the ATV or DTV input button.) The TV will now auto scan and learn the available channels. This process may take up to 15 minutes to complete. SunBriteTV Model 5510HD Operator’s Manual Page 21...
On-Screen Display Menu - Channel Menu TV mODe Press Menu button on the remote control to show Channel, Picture, Sound, Time, Option, Lock menu. Press OK button to select specific submenu and the adjustable value. In the submenu, press pq or t u button to select menu item.
(this menu is only available when PC-RGB is selected) Press pq to select Screen mode, and then press OK to enter submenu in pc mode. Select this option to auto adjust the RGB timing or to fine tune the display. SunBriteTV Model 5510HD Operator’s Manual Page 23...
Adjusting On-Screen Displays – Sound Menu sound menu sound mode Press pq to select Sound Mode, and then OK button, press t u buttons to select sound presets standard, music, movie, sports. Select user to select custom sound settings. Balance Press pq to select Balance, and OK button to enter submenu, press t u buttons to adjust balance value.
Press pq to select Auto Standby off and then Ok button to set and select 3h/4h etc Time Zone Press pq to select Time Zone, and then OK button to enter submenu, and press pq or t u to adjust the time zone. SunBriteTV Model 5510HD Operator’s Manual Page 25...
Adjusting On-Screen Displays – Option Menu Option menu OsD language Press pq to select OSD Language, and then OK button. Press pq or t u button to choose language choices. audio language Press pq to select Audio Language, and then OK button to enter submenu, and then press t u to select primary or secondary type.
Press pq to select Block Program, and then OK button to enter the submenu and then green button to choose lock/ unlock mode. Parental guidance Press pq to select Parental Guidance, and then OK button to select off/4/5 etc. SunBriteTV Model 5510HD Operator’s Manual Page 27...
1. Clean the window by using the following directions: To clean the SunBriteTV window, use glass cleaner and a lint-free or micro-fiber cloth. Spray the solution on the cloth and then apply to the window. DO NOT use acrylic cleaners.
Specifications specifications for sunBriteTV model 5510HD specifications Side View Front View LCD Screen 55-inch diagonal TFT Active Matrix Resolution 1920 x 1080 full-HD 1080p, 120 Hz Frame Rate Aspect Ratio 16:9 Contrast Ratio 5000:1 Viewing Angle Response Time 6.5 milliseconds...
Your SunBriteTV will be replaced under warranty if it meets one of the following criteria: —A total of 7 defective pixels, including both bright dots and dark dots are present. (Model 5510HD LCD TV screen has over a million pixels.) —2 or more pairs of adjacent bright dots are present.
Com Specs: 9600 baud 8 data, 1 stop, no parity Rx Data Tx Data Ground From control to control system system SunbriteTV RS232 Control Cable SIZE FSCM NO DWG NO July 17 2007 Preliminary 1 OF 1 SCALE SHEET SunBriteTV Model 5510HD Operator’s Manual Page 33...
Need help?
Do you have a question about the 5510HD and is the answer not in the manual?
Questions and answers