Marquis Spas THE QUEST Operating And Troubleshooting Manual

spa control operation
THE QUEST
PUMP PRIMING (Pr)
Pump priming feature begins at start-up. When your spa
is energized, the LCD window displays a "Pr" message.
This mode lasts approximately four to five minutes, if
not exited manually by pressing the TEMP pad.
UNDERWATER AND ENTRYWAY LIGHTS
Press the LIGHT pad to turn the underwater and
Entryway lights on and off. The low-voltage system
produces a night light for evening use and makes
entering and exiting the spa safer. After being on for
60 minutes, the lights automatically turn off.
AQUA AMBIANCE™
Use SPA LIGHT pad. Step one: turn on light. Step two:
turn off and then on within 2-3 seconds. Repeat for
all options: white, aqua, violet, blue, gold, green, red,
color wash, and blinking party mode. When switched
off for over 10 seconds your last color mode will be
saved in memory. To reset synchronization (two light
systems) turn light off for 5 seconds and turn back on.
WATERFALL FEATURE
The Waterfall feature and Convenience Center
attaches securely to the dual Vortex skimmer tops.
The water flow is controlled by an independent valve.
NOTE: Don't remove the waterfall top while the
pumps are running.
JETS
Use the JETS pad on the bather panel or remote
control. First press of the JETS pad activates pump
on low-speed (and starts soak timer). Second press
REMOTE CONTROL of the JETS pad activates pump on high-speed. Third
press of the JETS pad turns jets off for all-quiet mode.
Fourth press of the JETS pad turns pump back to
low-speed. If the pump is already on low (heating,
filter cycle) then the first press starts the soak timer.
After running on low- or high-speed for 15 minutes,
PAGE 27
the pump automatically turns off (unless in heating or
filtering cycle).
M A R Q U I S S P A S