Removing The Hard Disk Drive (User-Replaceable); Figure 2-3. Removing The Hard Disk Drive; Table 2-5. Hard Disk Drive Replacement Part Numbers - HP OmniBook 4100 Service Manual

Removing the Hard Disk Drive
(User-Replaceable)
Description
Drive, hard disk (4.0GB, IBM)
Drive, hard disk (4.0GB, Toshiba)
Drive, hard disk (6.4GB, IBM)
Required Equipment
• Small Phillips screwdriver.
• Small flat-blade screwdriver.
Removal Procedure
1. Unplug the ac adapter, if present, and remove the battery.
2. Turn the unit bottom side up.
3. Remove the hard drive screw from the bottom case.
4. Pull out the hard drive by its plastic tab.
Screw, M3×4mm
5. If you are installing a new hard drive that does not have a cover, you can remove the cover parts
from the old hard drive:
• Remove the screw from the case, then pry open the flap. If necessary, use a flat-blade
screwdriver
• Use a flat-blade screwdriver to pry open the snaps at the ends of the case, then open the
connector-side of the case.
• Pry out the corner next to the connector, then lift out the connector and hard drive together.
• Unplug the internal connector and cable from the hard drive.
HP OmniBook 4100

Table 2-5. Hard Disk Drive Replacement Part Numbers

Figure 2-3. Removing the Hard Disk Drive

Part Number Exchange
Part Number
0950-2671 F1386-69100
0950-2865 F1386-69101
0950-2785 F1475-69100
Removal and Replacement 2-5