Programming The Water Hardness Level - Miele Standard Operating Instructions Manual

Programming the water hardness
level
Each time a button is pressed, one of
the indicator lights will flash and light
up in the control panel. However, only
the indicator lights mentioned in the
following programming process stages
are significant.
The programming procedure can be
cancelled at any time by pressing the
K button. The procedure can then be
re-started from the beginning again.
^ Switch the dishwasher off with the
On/Off button K, if it is switched on.
^ Press the Start/Stop button in and,
whilst holding it in, switch the
dishwasher on using the On/Off
button K.
Keep the Start/Stop button pressed in
for at least four seconds until the
"Start/Stop" indicator light comes on.
If this does not happen, start the
procedure from the beginning again.
^ Press the Delay start button twice.
The Delay start indicator will flash
briefly twice at intervals.
Before using for the first time
The characters "p 1" will flash one after
the other in the display.
This means that the water hardness
level has been set at 1 °d (0.2 mmol/l)
(factory setting).
The value which has been set for the
water hardness is shown as a figure
after the "p" in the display (see chart).
^ Use the Start/Stop button to select
the number of flashes which equates
to your water hardness level.
Each press of the button moves you
up a level. When the highest water
hardness level is reached, the setting
starts from the beginning again.
^ Switch the dishwasher off with the
On/Off button K.
21