Antec P280 White Window User Manual page 21

There may come a time when you need to reconfigure the pin-out of a motherboard header
connector. Examples could be for your USB header, audio input header, or some other front
panel connector such as the Power Button connector.
Before performing any work, please refer to your motherboard user's manual or your
motherboard manufacturer's website to confirm the pin-out needed for your connector. We
strongly recommend making a notated drawing before beginning work so that you can recover
if your work gets disturbed.
Determine which wires you need to remove in order to rewire your plug to match the USB pin-
outs on your motherboard (refer to your motherboard user's manual). Working on one
connector at a time, use a very small flathead screwdriver or similar tool to lift up on the black
tab located beside the gold posts (squares). This will allow you to easily slide out the pins from
the USB plug.
Working carefully so as not to damage the wires, connectors, or pins, slowly remove the pin
from the connector. Repeat these steps for each wire you need to change.
Working carefully so as not to damage the wires, connectors or pins, slowly insert the pin into
the correct slot of the connector then snap closed the black tab that was lifted in step 1. Repeat
these steps for each wire you need to change.
19