Panasonic Pure IP-PBX KX-TDE600 Installation Manual page 198

3.15.1 Starting the PBX
System Initialization Procedure
1.
Slide the System Initialize Switch to the "SYSTEM INITIALIZE" position.
2.
Plug the AC power cord into the PBX and an AC outlet, and turn on the PBX. The RUN indicator will flash.
Note
For safety reasons, do not stretch, bend, or pinch the AC power cord.
To AC Outlet
3.
While the RUN indicator is flashing, slide the System Initialize Switch back to the "NORMAL" position.
Depending on the configuration, initialization takes about 1 min to 3 min. If successfully executed, the
RUN indicator will stop flashing and stay lit.
All data will be cleared, and the PBX as well as all optional service cards (except for the IP-GW card) will be
initialized to the default values. The DPTs should show the time as 01:00.
The data of the IP-GW card will not be initialized.
Note
When initializing the PBX, the built-in ESVM card will also be initialized. Therefore, the built-in ESVM card
feature may not be used for up to 2 minutes after the PBX starts.
198 Installation Manual
RUN Indicator
Reset Button
INITIALIZE
System Initialize Switch
RESET
SYSTEM
NORMAL
Document Version 2009-12