Viewpower Configuration; Password Configuration; Sms Configuration - Salicru SPS.ONE User Manual

4. ViewPower Function
Menu
4.1

ViewPower Configuration

4.1.1 Password Configuration

It's password configuration for administrator only. Before op-
erating and configuring the software, please login first and
modify the password. The default password is "adminis-
trator" at first log in. Users can only browse UPS status and
information as Guest status without login as an Administrator.
Guest can NOT control or executive any setting.
Modify password
• Step 1 Select ViewPower Configuration>>Password.
Refer to Diagram 16.
Fig. 16.
• Step 2 Enter old password, new password, and retype
new password in confirm password column to modify
password for administrator. (The password should be at
least 6 digits) Then click "Apply" button to successfully
modify password for administrator.
NOTE: Simply click "Login" button on the top right corner
to log in the software.

4.1.2 SMS Configuration

It's for entering SMS receiver list. In the event of an alarm con-
dition occurring, a message about UPS status will be sent to
the specified users via mobile phone. For the event receiving
list, please configure in "Event Action" column (refer to sec-
tion 4.1.4).
S A L I C R U
• Step 1 Choose ViewPower Configuration >> SMS. Refer
to Diagram 17.
Fig. 17.
• Step 2 Select communication port and baud rate.
• Step 3 Enter mobile phone numbers in "Phone no." column
and click "Add" button to add phone no. in Receivers List.
To delete numbers, simply select phone no. from "Re-
ceivers list" and click "Delete".
• Step 4 Click "Apply" button to save all changes. The
"Test" button can be used to send test SMS to confirm
the correct operation. If all parameters are set up cor-
rectly, system will send a test message to all receivers
and pop up a successful message. (Refer to Diagram 18)
Otherwise, it will pop up a failure dialog to indicate there is
an error for parameter setting. (Refer to Diagram 19).
Fig. 18.
Fig. 19.
VIEWPOWER FUNCTION MENU
9