Changing Wheels - MARUTI SUZUKI CELERIO Owner's Manual & Service Booklet

MH0-74E
Rear jacking point for garage jack (2)
(2)
Application point for jack stand (3)
or two-column lift
(3) (3)
179
Never apply a garage jack to the
EXAMPLE
exhaust pipe, side under spoiler (if
equipped), engine undercover or rear
torsion beam.
NOTE:
For more details, please contact an
authorized MARUTI SUZUKI dealer.

Changing Wheels

To change a wheel, use the following
procedure:
1) Clear all passengers and luggage from
MH0-07-014
the vehicle.
2) Remove the jack, tools and spare wheel
from the vehicle.
EXAMPLE
3) Loosen, but do not remove the wheel
nuts.
4) Jack up the vehicle.
5) Remove the wheel nuts and wheel.
6) Before installing the new wheel, clean
any mud or dirt off from the surface of
the wheel and hub with a clean cloth.
Clean the hub carefully; it may be hot
from driving.
7) Install the new wheel and replace the
wheel nuts with their cone shaped end
facing the wheel. Tighten each nut
MH0-07-014
snugly by hand until the wheel is
securely seated on the hub.
NOTICE
EMERGENCY SERVICE
Tightening torque for wheel nut
85 Nm (8.7 kg-m, 62.7 lb-ft)
8) Lower the jack and fully tighten the nuts
in a crisscross fashion with a wrench as
shown in the illustration.
WARNING
Use genuine wheel nuts and tighten
them to the specified torque as soon
as possible after changing wheels.
Incorrect wheel nuts or improperly
tightened wheel nuts may come loose
or fall off, which can result in an
accident. If you do not have a torque
wrench, have the wheel nut torque
checked by an authorized MARUTI
SUZUKI dealer.
EXAMPLE
MH0-07-014
10-3