Basic Troubleshooting; Diagnostic Fault Codes; Fault Code Display - Pride Mobility COLT PURSUIT Owner's Manual

V I I I . B A S I C T R O U B L E S H O O T I N G
Any electromechanical device occasionally requires some troubleshooting. However, most of the prob-
lems that may arise can usually be solved with a bit of thought and common sense. Many of these problems
occur because the batteries are not fully charged or because the batteries are worn down and can no longer
hold a charge.

DIAGNOSTIC FAULT CODES

The diagnostic fault codes for your scooter are designed to
help you perform basic troubleshooting quickly and easily.
A diagnostic fault code and error message will be displayed
(see figure 26) in the event one of the conditions listed
below develops.
NOTE: Your scooter will not run unless the fault code
condition is resolved and the scooter has been turned off,
then turned back on.
FAULT CONDITION
CODE
1 Batteries need charging
2 Low voltage, batteries need
charge immediately
3 Over Voltage
4 Over Current
5 Park brake fault
6 Throttle control lever not
centred at start up
7 Throttle control lever broken
or faulted
8 Motor fault
9 Other fault
38
SOLUTION
Charge batteries as soon as possible.
Charge batteries as soon as possible.
Unplug charger and/or turn scooter off, then
back on.
Turn scooter off for a few minutes, then turn
scooter back on.
Remove the key from the key switch, then push
the manual freewheel lever to the drive
(rearward) position and restart your scooter.
Return the throttle control lever to centre
position, turn scooter off, then back on.
Contact your authorised Pride Dealer.
Contact your authorised Pride Dealer.
Contact your authorised Pride Dealer.
www.pridemobility.com
FAULT CODE
Figure 26. Fault Code Display
ERROR
MESSAGE
ERROR
MESSAGE
N/A
LO BAT
HI BAT
HI CUR
BRAKE
T POT
T POT
MOTOR
OTHER
Colt Pursuit