Isuzu 1999 RODEO Workshop Manual page 2032

MANUAL TRANSMISSION
7B–66
9. Remove the 8 bolts that hold the extension housing to
the case, using a 15 mm wrench.
Note that two bolts use sealer.
Separate the extension housing assembly(2) from
the case and shift cover. The offset lever(3) will also
separate from the shift shaft.
NOTE: Do not attempt to remove the offset lever while
the extension housing is still bolted to the case. The lever
has a positioning lug which engages the detent/guide
plate and prevents moving the lever far enough to remove
it.
10. Remove the offset lever(3) from the extension
housing, along with the detent ball(3) and spring(3).
Remove the roll pin(1) from either the offset lever or
extension housing.
11. Carefully pry the oiling funnel(4) from the rear of the
counter shaft. This may be a very snug fit, and the
funnel may become damaged during removal unless
extreme care is used.
12. Remove the 10 bolts that hold the shift cover to the
case, using a 10 mm wrench.
NOTE: Two of the shift cover bolts are also alignment
dowels. Note the location of these bolts for assembly.
Remove the shift cover assembly(5) from the case by
sliding it sideways toward the drain plug side of the
case for a distance of 1 inch. Then lift the cover
220RW059
straight up from the case. You may need to break the
sealer bond between the cover and case before you
can separate them.
230RS014
226RS097
230RS015