Bagging The Clippings; Recycling The Clippings; Installing The Grass Bag - Toro 20056 Operator's Manual

7. Release the blade control bar.
8. Immediately push the mower over the newspaper ball.
9. Stop the engine and wait for all moving parts to stop.
10. Go to the front of the mower and check the newspaper
ball.
Note: If the newspaper ball did not go under the
mower, repeat steps 4 through 10.
11. If the newspaper is unravelled or shredded, the blade
did not stop properly, which could result in an unsafe
operating condition. Contact an Authorized Service
Dealer.

Recycling the Clippings

Your mower comes from the factory ready to recycle the
grass and leaf clippings back into the lawn.
If the grass bag is on the mower, remove it (refer to
Removing the Grass Bag) before recycling the clippings. If
the side discharge chute is on the mower, remove it and
lock the side discharge door (refer to Removing the Side
Discharge Chute) before recycling the clippings.
Important: Ensure that the rear discharge plug is in
place before you recycle the clippings (Figure 34).
Figure 34

Bagging the Clippings

Use the grass bag when you want to collect grass and leaf
clippings from the lawn.
A worn grass bag could allow small stones and
other similar debris to be thrown in the operator's or
bystander's direction and result in serious personal
injury or death to the operator or bystanders.
Check the grass bag frequently. If it is damaged,
install a new Toro replacement bag.
If the side discharge chute is on the mower, remove it and
lock the side discharge door (refer to Removing the Side
Discharge Chute) before bagging the clippings.
The blade is sharp; contacting the blade can result
in serious personal injury.
Stop the engine and wait for all moving parts to stop
before leaving the operating position.

Installing the Grass Bag

1. Raise and hold up the rear door (Figure 35).
13