Canopy; Newborn Insert - Chicco KeyFit 30 User Manual

CANOPY

To Adjust Canopy, grab bow on both
sides and rotate. Detach fastener tabs
when rotating toward front of carrier.
To Remove Canopy Fabric,
a
pull fabric away from Canopy Mount
to expose button. Press button on
canopy mount to release end of bow.
Slide canopy fabric off bow and detach
canopy from rear of pad.
Release bow from canopy
mount on opposite side of carrier
if using carrier without canopy.
To replace canopy, reverse previous
steps.
To extend/retract visor
To retract the visor, gently push it
b
downward and allow it to pop up under
the canopy. The canopy must be
extended before attempting to retract
the visor.
To extend the visor, gently pull
c
it downward from underneath the
canopy and allow it to pop into its
extended position.
a
b
c
20

NEWBORN INSERT

Use Newborn Insert to provide
additional support and ensure
a secure harness fit for smaller
infants.
The harness height may
have to be changed to fit your
child. Before using insert, read
the instructions on "Changing
Harness Height" and "Securing
Child in Carrier"
To Install Insert in Carrier
Pull End of Buckle through
1
center slot in insert.
Pull Both Harness Straps over
2
and around side panels. Push
insert firmly into bottom of carrier.
Top of insert should always be
BELOW the lower harness slots.
When properly installed,
3
the Newborn Insert and harness
should look like drawing.
ONLY USE the Newborn Insert in the lowest harness position,
and only if the child weighs between 4 and 11 pounds (2 and
5 kg). Always use the proper harness slots for the child's height,
see page 25.
1
2
3
21