Steering mounted controls
WINDSCREEN WIPER STALK
Manual windscreen wipers
2
Fast wipe (heavy rain).
1
Normal wipe (moderate rain).
l
Intermittent wipe.
0
Off.
Single wipe
(press downwards).
In the I ntermittent position, the wiping
speed is in proportion to the vehicle
speed.
Whenever the ignition has been
switched off for more than one minute,
with the windscreen wiper stalk in
position 2, 1 or I, the stalk must be
reactivated:
-
move the stalk to any position,
-
then move it back to the required
position.
Automatic rain sensitive windscreen wipers
Do not cover the rain sensor,
located in the centre of the
windscreen, behind the mirror.
In the AUTO position, the windscreen
wipers operate automatically and
adapt their speed to the intensity of the
rainfall.
When not in AUTO mode, for the
other positions, refer to the manual
windscreen wipers section.
Activation
Press the control downwards.
Activation of the function is
accompanied by a message in the
screen.
The automatic rain sensitive
windscreen wipers function must
be reactivated by pressing the stalk
downwards, if the ignition has been
switched off for more than one minute.
Deactivation / Switching off
Place the windscreen wipers stalk in
position I , 1 or 2 . Deactivation of the
function is accompanied by a message
in the screen.
In the event of malfunction of the
automatic windscreen wipers, the
windscreen wipers will operate in
intermittent mode.
Contact a PEUGEOT dealer or a
qualifi ed workshop to have the system
checked.
When using an automatic car
wash, switch off the ignition to
avoid triggering the automatic
wiping.
In winter, it is advisable to wait for the
windscreen to completely clear of ice
before operating automatic wipe.
Need help?
Do you have a question about the PARTNER Tepee and is the answer not in the manual?
Questions and answers
What are the driver information screen showing in trip 1, trip 2
The driver information screen in a PEUGEOT PARTNER Tepee displays the following for both trip 1 and trip 2:
- Average speed: Calculated since the last trip computer reset.
- Current fuel consumption: Displayed only when speed is above 20 mph (30 km/h).
- Average fuel consumption: Calculated over the route since the last trip reset.
- Distance travelled: Measured since the last trip reset.
- Distance remaining to the destination: Calculated based on the final destination set by the user. If navigation guidance is active, the system updates this value dynamically.
The driver can cycle through these details by pressing the button at the end of the wiper stalk.
This answer is automatically generated