Griffin Technology iTrip Auto Quick Start Manual

Quick Start Guide
Thank you for purchasing Griffin's iTrip Auto, the easiest way to play your Sansa through your
car's FM radio. Setting up iTrip is a breeze. Follow these few simple steps and you'll be ready
to go in no time.

Getting Started

1. Start by tuning your FM radio to an unused station. Select a frequency on which you hear
nothing but static. The ideal choice would be a frequency whose neighboring frequencies
on both sides are also clear. For example: 88.3 would be an ideal choice if it is open and
88.1 and 88.5 are clear as well.
2. Plug iTrip's charging cable into your car's cigarette lighter or power outlet. This will power
your iTrip, and allow you to charge your Sansa at the same time. (Note, though, that some
Sansa models, including the c140 and c150, are not rechargeable. iTrip will provide playback
for these models, but not charging.) Attach iTrip's dock cable to the Sansa's 30-pin connector
and begin playing music.
+ -
3. Press iTrip's and buttons to adjust its frequency to match the open station you selected on
your radio, above. You can press and hold the
faster. iTrip will automatically lock in a frequency as you release the button. Your music will
now be playing through your speakers. Use the volume controls on your radio to set your
music to a comfortable level.
That's it! Repeat Step 3 whenever you need to change iTrip's frequency settings while traveling.
Using iTrip Auto's Presets
iTrip Auto automatically remembers its most recently-used frequency, but you can also save the
best frequencies as presets for easy recall.
First, tune iTrip Auto to the frequency you want to save. Then, press and hold the preset button
until a preset begins to flash (1, 2, 3, or 4 may appear in iTrip's display at this time). Select the
desired preset location (1, 2, 3, or 4) by pressing the + or - button repeatedly. Then wait 2 seconds
and iTrip will save the preset for later use.
To recall a saved preset, press the preset button to step through presets 1, 2, 3, and 4. iTrip will
automatically lock in that frequency as you release the button.

LX/DX Mode for Best Sound

Some audio content, such as audio books, will sound much the same in either stereo or mono.
Since mono mode produces a stronger signal, you may choose to listen in mono, especially in
populated areas where there are a lot of active stations crowding the radio dial.
Charge and play your Sansa
through your car radio
+ -
and buttons to scan through the frequencies
®
®