Turning The Appliance On; Turning The Appliance Off; Auto-Off; Energy Saving - DeLonghi ECAM 22.110 User Manual

1� Remove the water tank, fill to the MAX line with fresh
water (fig� 1A) then put back in the appliance (fig� 1B)�
2� Place a container with a minimum capacity of 100 ml
under the cappuccino maker (fig� 2)�
3� Plug the appliance into the mains socket and place the
main switch on the back of the appliance in the I position
(fig� 3)�
4� The light flashes on the control panel (fig� 4)�
5. Turn the steam dial to the "I" position (fig. 5). The
appliance delivers water from the cappuccino maker then
goes off�
6. Turn the steam dial to the " 0" position.
The coffee maker is now ready for normal use�
Please note :
• When using the appliance for the first time, you need to
make 4-5 cups of coffee or 4-5 cappuccinos before the
appliance starts to give satisfactory results�

tURnInG the APPlIAnCe on

Please note :
• Before turning the appliance on, make sure the main
switch on the back of the appliance is in the I position (fig�
3)�
• Each time the appliance is turned on, it performs an
automatic preheat and rinse cycle which cannot be
interrupted� The appliance is ready for use only after
completion of these cycles�
Danger Of burns!
During rinsing, a little hot water comes out of the coffee spouts
and is collected in the drip tray underneath�
Avoid contact with splashes of water�
• To turn the appliance on, press the
corresponding light flashes while the appliance is
heating up and performing an automatic rinse cycle (by
circulating hot water, the appliance heats both the boiler
and the internal circuits)�
The appliance is at temperature when the
the lights corresponding to the coffee buttons come on�

tURnInG the APPlIAnCe oFF

Each time the appliance is turned off, it performs an automatic
rinse cycle which cannot be interrupted�
Danger Of burns!
During rinsing, a little hot water flows from the coffee spouts�
Avoid contact with splashes of water�
To turn the appliance off, press the
appliance performs a rinse cycle, then goes off�
If the appliance is not used for an extended period, also place
the main switch in the 0 position (fig� 3)�
To avoid damaging the appliance, do not place the main switch
(fig� 3) in the 0 position until the appliance has been turned off
using the

AUto-oFF

The appliance is set to turn off automatically if not used for 2
hours�
The time can be changed so that the appliance switches off
after 15 or 30 minutes, or after 1, 2 or 3 hours�
The set the auto-off, proceed as follows:
1� With the machine off and the main switch in I position
2� Press the
3� Press the
(fig� 6): The

eneRGy sAVInG

Use this function to enable or disable energy saving mode�
When enabled, the function reduces energy consumption in
compliance with European regulations�
Energy saving mode is active when the green ECO light is on
light goes off and
(fig� 7)�
1� With the appliance off and the main switch in the I
2� To disable the mode, press the
3� To re-enable the mode, press the eCo button (on the left
4� Press the
10
Please note :
Important!
button�
(fig� 3), press the button and keep it pressed until the
lights on the control panel come on�
button (on the left side of the dial) until
the lights corresponding to the number of hours before
the appliance goes off automatically come on:
15 minutes eCo
eCo
30 minutes
1 hour eCo
2 hours eCo
eCo
3 hours
button (on the right side of the dial) to
confirm; the lights switch off�
position (fig� 3), press the
until the eCo light comes on (fig� 7)�
the dial)� The eCo light flashes�
again� The eCo light comes on steadily�
of the dial)
button (on the right of the dial) to
button (fig� 6)� The
button and hold it down
button (on the left of