Ford Focus 2001 Workshop Manual
  1. Manuals
  2. Brands
  3. Ford Manuals
  4. Automobile
  5. Focus 2001
  6. Workshop manual

Ford Focus 2001 Workshop Manual

Steering column
Hide thumbs Also See for Focus 2001:
1
2
3
4
5
6

Advertisement

Table of Contents

See also: Workshop Manual
2001 Focus Workshop Manual
SECTION 211-04: Steering Column
DISASSEMBLY AND ASSEMBLY
Steering Column

Material

Grease
Disassembly
All vehicles
1. Remove the two multifunction switches.
1. Depress the retaining tangs.
2. Lift the switches upwards.
2. Detach the driver air bag module from the steering wheel.
3. Remove the driver air bag module.
Release the three clips.
Disconnect the air bag module electrical connector.
4. Remove the passive anti-theft system (PATS) transceiver.
5. Remove the steering wheel.
1. Disconnect the speed control electrical connector (if equipped).
2. Remove the steering wheel retaining bolt.
6. Remove the tolerance ring.
http://www.fordtechservice.dealerconnection.com/pubs/content/~...
WSD-M1C230-A
Page 1 of 6
2001 Focus Workshop Manual
Procedure revision date: 04/16/2002
12/6/2009

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Focus 2001 and is the answer not in the manual?

Questions and answers

Related Manuals for Ford Focus 2001

Summary of Contents for Ford Focus 2001

  • Page 1 2001 Focus Workshop Manual Page 1 of 6 SECTION 211-04: Steering Column 2001 Focus Workshop Manual DISASSEMBLY AND ASSEMBLY Procedure revision date: 04/16/2002 Steering Column Material Grease WSD-M1C230-A Disassembly All vehicles 1. Remove the two multifunction switches. 1. Depress the retaining tangs. 2.
  • Page 2 2001 Focus Workshop Manual Page 2 of 6 7. NOTE: Make sure the clockspring is not allowed to rotate. Secure in the central position with a piece of suitable tape. Remove the clockspring. Using a thin bladed screwdriver, release the two retaining clips. 8.
  • Page 3 2001 Focus Workshop Manual Page 3 of 6 13. Separate the steering column two halves. Vehicles with stability assist 14. Remove the steering wheel rotation sensor clamp. 1. Remove the screws. 2. Using a thin bladed screwdriver, depress the locking tangs and remove the steering wheel rotation sensor clamp. 15.
  • Page 4 Install the steering wheel rotation sensor clamp. 1. Install the screws. 2. Apply grease to Ford specification, to the steering column splines. All vehicles 4. NOTE: Make sure the steering column shafts are aligned correctly. Connect the steering column two halves.
  • Page 5 2001 Focus Workshop Manual Page 5 of 6 8. Install the passive anti-theft system (PATS) transceiver. WARNING: Make sure the clockspring is centralized before installing. Failure to follow this instruction may result in personal injury. Centralize the clockspring. 1. Turn the clockspring in a COUNTERCLOCKWISE direction until a resistance is felt (approximately 2.5 turns from the central position). 2.
  • Page 6 2001 Focus Workshop Manual Page 6 of 6 13. Install the driver air bag module. Connect the air bag module electrical connector. 14. Attach the driver air bag module to the steering wheel. http://www.fordtechservice.dealerconnection.com/pubs/content/~... 12/6/2009...

Table of Contents

Save PDF