Table of Contents
Advertisement
Turn the bulb socket counterclockwise and remove
it.
Pull the bulb out of the socket and replace it with a
new one.
Make sure that the seal rubber is installed in
position and is in good condition.
Route the taillight
Install the removed parts in the reverse order of
wire properly.
removal.
INDICATOR (U.S.A. TM/FM model
only)
Remove the handlebar cover (page 12-3).
Raise the rubber socket toward upper side to
remove it off the cover.
Remove the indicator lens and turn the socket
inside out.
Pull the bulb out of the socket and replace it with a
new one.
Align the socket
Installation is in the reverse order of removal.
lugs with the cover
grooves.
HEADLIGHT
REMOVAL/INSTALLATION
Remove the headlight bulb (page 20-2).
Remove the following fasteners:
aim adjusting bolt and lock washer
mounting bolt
four mounting screws
Remove the headlight assembly from the headlight
grill and the headlight from the cover by releasing
the tabs from the slits.
Route the
Installation is in the reverse order of removal.
headlight wire
between the cover
Adjust the headlight aim (page 20-3).
and headlight
properly ( page 1-
22).
SCREWS
WASHER
ADJUSTING BOLT
LIGHTS/METERS/SWITCHES
BULB
TAB
SLIT
MOUNTING BOLT
COVER
SOCKET
RUBBER SOCKET
HEADLIGHT
WIRE
20-3
- Quick Links:
- Torque Values
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the TRX350TM Rancher and is the answer not in the manual?
Questions and answers
Fuel drains out through the drain line
hi, please tell me which direction is the recoil pulley bolt , honda part# 90081-hn5-670 supposed to unscrew on a 2003 honda rancher to access the stator an pulls generator. thank you kindly joe.