Cvbs; Hdmi; Keyboard Connection (Only Divar 5000) - Bosch DVR-3000 Operator's Manual

DIVAR 3000/5000 Digital Video
Recorder
5.3.2

CVBS

Connect the monitor A CVBS and/or monitor B CVBS output to monitors using 75 ohm video
coaxial cables with BNC connectors.
Specifications
Output signal: Composite video 1 Vpp, 75 ohm, Sync. 0.3 Vpp ±10%
Resolution: 704x576 PAL, 704x480 NTSC
Connector type: BNC
5.3.3

HDMI

Connect the unit to a HDMI equivalent monitor using standard HDMI cable.
Specifications
Output signal: Digital RGB, 165 MHz
Resolution: 1920x1080, 1280x1024, 1280x720, 1024x768
Connector type: HDMI
5.4

Keyboard connection (only DIVAR 5000)

The keyboard connection is used to connect a Bosch Intuikey keyboard to a DIVAR 5000 unit.
For short distances (up to 30 m), standard 6-core telecom flat cable can be used to supply
signal connections for the keyboard (LTC 8558/00). Always use the Keyboard Extension Kit
(LTC 8557) for distances over 30 m between the keyboard and the DVR; this kit provides
junction boxes and cables. The appropriate power supply to externally power the keyboard
must be purchased separately. The recommended cable type is Belden 8760 or equivalent.
Connection
There are 2 possible ways to connect your Bosch Intuikey keyboard:
–
Figure 5.1: RJ11 adaptor
–
Bosch Security Systems
Using the RJ11 adaptor – see following figure.
Or, connect the keyboard RJ11 wires to the Keyboard connector on the DIVAR back
panel as shown in the following figure.
Operator Manual
Hardware setup | en
2013.05 | 1.0 | DIVAR 3000/5000 Digital Video
29
Recorder