Physical Interfaces Commands - Motorola Netopia Administrator's Handbook

Administrator's Handbook
set management web http-port [ 1 - 65534 ]
Specifies the port number for HTTP (web) communication with the Motorola Netopia® Gateway. Because port
numbers in the range 0-1024 are used by other protocols, you should use numbers in the range 1025-65534 when
assigning new port numbers to the Motorola Netopia® Gateway web configuration interface. A setting of 0 (zero)
will turn the server off.
set management web idle-timeout [ 1...120 ]
Specifies a timeout period of inactivity for HTTP access to the Gateway, after which a user must re-login to the
Gateway. Default is 5 minutes for HTTP.
☛
NOTE:
You cannot specify a port setting of 0 (zero) for both the web and telnet ports at the same time. This
would prevent you from accessing the Gateway.

Physical interfaces commands

set physical dsl enable [ off | on ]
Turns the physical DSL interface off or on. Default is on.
set physical dsl loopback [ off | on ]
Turns the DSL loopback mode off or on. Default is off.
set physical dsl modulation auto [ off | on ]
Turns automatic DSL modulation off or on. Default is on.
set physical dsl profile-8a [ off | on ]
Default is on.
set physical dsl profile-8b [ off | on ]
Default is on.
set physical dsl profile-8c [ off | on ]
Default is on.
set physical dsl profile-8d [ off | on ]
Default is on.
set physical dsl profile-12a [ off | on ]
Default is on.
74