Panasonic KX-TAW848 Installation Manual page 112

3.3 Installation of the PC Programming Software
Starting the KX-TAW848 Maintenance Console and Assigning the Basic
Items (Quick Setup)
When you start the KX-TAW848 Maintenance Console with the Installer Level Programmer Code and
connect to the PBX for the first time after initialization (with the factory default setting), Quick Setup will
launch automatically. During Quick Setup, you will set up the following basic items. For details about the
basic items, refer to "1.14.2 Quick Setup" in the Feature Manual.
112 Installation Manual
1. Connect the PC to the PBX with a USB cable.
2. Start the KX-TAW848 Maintenance Console from the
Start menu.
3. "Information before programming" appears.
a.
Carefully read this important additional information,
which includes updates to this and other manuals.
b.
Click OK to close this window.
4. Enter the Installer Level Programmer Code (default:
INSTALLER).
The Programmer Code authorizes different
programming levels, and the Quick Setup is only
available when you start the KX-TAW848 Maintenance
Console with the Installer Level Programmer Code.
Note
There are 2 other Programmer Codes with limited
authorization: Administrator Level (default:
ADMIN), and User Level (default: USER).
5. a.
Click the check box to connect to the PBX. Options
will appear as shown here, on the left.
b.
Enter the system password for installer (default:
1234).
c.
Select "USB", then click OK.
Note
To connect to the PBX via USB, the KX-TDA USB
driver must be installed on the PC, as explained
above in "Installing the KX-TAW848 Maintenance
Console".
6. Follow the instructions of the Quick Setup wizard and
assign the basic items (Quick Setup).