Water Services - Auto-Trail Cheyenne Owner's Handbook Manual

: Owner's Handbook
Filling The Fresh Water Tank
The tank is filled via a lockable water inlet on
the outside of your vehicle.
This inlet is identified by a blue tap symbol adjacent
to it (either a blue label or a blue moulding on the
filler itself).
The location of the water inlet will vary from vehicle
to vehicle so please familiarise yourself with its
location before using your vehicle for the first time.
Before attempting to fill your fresh water tank please
ensure that the cold water drain tap inside the
vehicle is in the closed position (see 'draining the
water system' section).
To Fill
• Remove the cap and insert a suitable length
of pipe.
• Connect the other end to a clean water supply
• Fill the tank until either the water level gauge
reads 100%, or until the tank begins to
overflow
• Remove the hose. Replace the cap, lock and
remove the key.
Please note, use only food or drug quality pipe.
Waste Water Tank
All waste water (excluding the toilet) is piped
into an onboard waste water tank located
underneath your vehicle. The volume of the waste
water tank will vary depending on which model you
have chosen.
When the waste tank becomes full (which will be
indicated by a visible and audible signal on control
panel), the tank should be emptied via the drain
valve on the outside of the vehicle over a suitable
drainage point.
When the 'tank full' indicator sounds there will still
be some capacity in the waste tank, but we would
advise that it is emptied as soon as possible.

Water Services

www.auto-trail.co.uk 34