Page 2
INSTEON Dimmer Switch Brightness LEDs Hold to Brighten Status LED Hold to Dim Heat Sink Tab Set Button (1000W Only) For the complete Owner’s Manual and more, visit: insteon.com/support...
Page 3
Tools Needed for Installation Phillips Screwdriver Flathead Screwdriver Voltage Detector Wire Cutter / Stripper Disconnect Power Always disconnect power before installation. Contact INSTEON Support when uncertain about installation. 1-866-243-8022...
Installation Turn off power to your switch at the electrical service panel. Circuit Breakers Fuse Panel Power is ON Power is OFF...
Page 5
Remove the old switch and disconnect the wires. If your box lacks neutral wires, stop and contact support. Neutral Wire ½” 12mm...
Page 6
Turn on power at the circuit breaker and use a voltage detector or multi-meter to identify line and load. Line will be energized.
Page 7
Turn off power at the circuit breaker. Connect the junction box. Verify that the wire nuts are s except for the bare ground wire. Load Line...
Page 8
the Dimmer Switch wires to the identified wires in secure and that no exposed copper wire is visible Neutral Ground...
Page 9
Mount the Dimmer Switch into the junction box with the LED bar on the left and turn power on to the switch at the circuit breaker panel.
Page 10
Test your Dimmer Switch by tapping the paddle to turn On and Off. Press and hold to dim or brighten. Installation complete. You can now link your Dimmer Switch to the Hub.
Page 11
Linking to the Hub Follow the on-screen instructions to add your Dimmer Switch to the INSTEON Hub. When prompted, press and hold the Dimmer Switch’s set button. If not using the Hub, refer to the instructions that came with your product.
Need help?
Do you have a question about the 2477D and is the answer not in the manual?
Questions and answers