Improving Your Coverage Area; Troubleshooting The Zboost Yx500/510 Series System - Wireless Extenders zBoost YX500 Series Installation Manual

wpsantennas.com
zBoost YX500/510 Series Installation Guide
Troubleshooting Your zBoost System
Base Unit Indicator Operation
In most cases, problems with zBoost can be diagnosed using the Base Unit's
LED indicators. Please note that for YX510, GREEN indicates CEL band
operation and AMBER indicates PCS band operation.
Power Install Signal
Light Light Light
Cycle RED Cycle RED Cycle RED
and and and
GREEN for GREEN for GREEN for
3 seconds 3 seconds 3 seconds
Solid Off Off
GREEN
Solid Off Flashing or
AMBER solid
or GREEN or
Solid GREEN
GREEN With
flashing
AMBER
Flashing Off Off
GREEN
Solid Flashing Off
AMBER RED
or or
Solid Solid RED
GREEN
Solid Solid RED Solid RED
AMBER
or
Solid
GREEN
Wi-Ex
Condition
Normal condition at Power Up
Normal condition with no cell call in
progress
Normal condition indicating that a call is in
progress and the system is providing
improved coverage. The Signal Light may
also flash periodically with no call in
progress indicating normal communication
between the cell phone and the cell
network.
Base Unit has detected a software error.
Remove power for 5 seconds and
reconnect power. If condition still exists,
contact Wi-Ex Customer Service.
Insufficient distance exists between the
Signal Antenna and the Base Unit. Indoor
coverage will be reduced. Increase
distance between Signal Antenna and Base
Unit to achieve maximum performance and
coverage. If condition persists after
relocating Signal Antenna and/or Base
Unit, contact Wi-Ex Customer Support for
additional information on Installation.
Signal received from cell tower is too
strong. Relocate Signal Antenna to a
different location to reduce received signal.
Locating the Signal Antenna at an indoor
location such as the attic or to a lower
height should reduce the received signal
strength. Remove power for 10 seconds
and reconnect power to reset error.
(877) 594-5766
15