Table of Contents
Advertisement
Problem
The DECT repeater's
& indicator and ID
indicator flash green
and red alternately
(alarm indication).
The handset registered
to the unit cannot
make/receive a call.
Specifications
N Standard: DECT (Digital Enhanced Cordless Telecommunications)
N Frequency range: 1.88 GHz to 1.90 GHz
N RF transmission power: Approx. 10 mW (average power per channel)
N Power source: 220-240 V AC, 50/60 Hz
N Power consumption: Standby: Approx. 0.8 W, Maximum: Approx. 1.6 W
N Operating conditions: 0 °C – 40 °C, 20 % – 80 % relative air humidity (dry)
Note:
L Design and specifications are subject to change without notice.
L The illustrations in these instructions may vary slightly from the actual product.
Cause/solution
L The ID of the DECT repeater is the same as the ID of
another DECT repeater that is registered to the same
base unit. Deregister both of the units, then re-register
them near the base unit.
Deregister:
1
Unplug the AC adaptor, then press and hold
{PROGRAM}.
2
While pressing and holding {PROGRAM},
re-connect the AC adaptor.
3
Keep pressing and holding {PROGRAM} for about
10 seconds until the & indicator stops flashing and
lights red. Then release {PROGRAM}.
L The & and w indicators light amber for about 2
seconds and the & indicator flashes red again.
L If the & indicator flashes green after releasing
{PROGRAM}, deregistration failed. Deregister
the unit again.
Re-register: Unplug the AC adaptor, then perform
from step 2, "Installation/Registering the DECT
repeater to the base unit", page 11.
L When the & indicator flashes green rapidly, a handset
registered to the unit cannot make/receive a call
through this unit. Close to the base unit or wait until the
& indicator flashes slowly or the & indicator is on.
15
Hide quick links:
Advertisement
Table of Contents
