Page 2
Please read this user manual first! Dear Customer, We hope that you get the best results from the product which has been manufactured in state-of-the-art plants and passed through a strict quality control procedure. Therefore, please read the entire user manual carefully before using the product and keep it as a reference for future use.
CONTENTS Dishwasher Adjusting the height of loaded upper basket Important safety instructions Adjusting the height of loaded General safety upper basket Intended use Adjusting the height of empty Children’s safety upper basket Installation Operating the product Appropriate installation location Keys Connecting water supply Preparing the machine Connection to the drain...
Technical specifications This product complies with the following EU directives: Development, production and sales stages of this product comply with the safety rules included in all pertaining European Community regulations. 2006/95/EC, 2004/108/EC, 93/68/EC, IEC 60436, EN 50242 Power input 220-240 V, 50 Hz Total power consumption 1900-2200 W Heater power consumption...
Important safety instructions This section contains safety cleaning and repairing procedures. • instructions that will help to get Always have the installation and protected from risk of personal injury repairing procedures carried out or property damage Failure to follow by the Authorised Service Agent. these instructions shall void all Manufacturer shall not be held warranties.
• This product should not be used by persons with physical, sensory or mental disorders or unlearned or inexperienced people (including children) unless they are attended by a person who will be responsible for their safety or who will instruct them accordingly for use of the product.
Installation Refer to the nearest Authorised flat floor that has sufficient load Service Agent for installation of your carrying capacity! The product product. To make the product ready must be installed on a flat surface for use, make sure that the electricity, in order for the door to be closed tap water supply and water drainage comfortably and securely.
Connection to the drain Permitted water temperature: up to 25°C Water discharge hose can directly be The dishwasher may not be connected connected to the drain hole or sink’s to open warm water devices or flow- drainage. The length of this connection through water heaters.
Adjusting the feet Electrical connection If the door of the product cannot be Connect the product to a grounded closed properly or if the product swings outlet protected by a fuse complying when you push it slightly, then you with the values in the “Technical need to adjust the feet of the product.
detergent while the machine is materials should not be disposed as empty. During the initial use, fill the normal domestic wastes. salt reservoir with 1 litre of water Refer to your local dealer or solid prior to filling it with salt. waste collection centre in your area to learn how to dispose of your product.
Prewashing Tips for energy saving Following information will help you use the product in an ecological and energy-efficient manner. • Wipe away any coarse food remnants on the dishes before putting them in the product. • Operate the product after filling it completely.
Adding salt � Water softening system needs to be regenerated in order for the product operates with the same performance continuously. Dishwasher salt is used for this purpose. Use in your product only the special softening salts produced particularly for use in dishwashers. We recommend using granular or powder softening salts.
5. If you will not start a washing Put the detergent into the detergent programme immediately after dispenser just before operating the adding the salt, run the machine machine as illustrated below. empty in the shortest programme 1. Push the latch to right to open the to dissolve and wash away the detergent dispenser lid (A).
3. Close the detergent dispenser lid rinse aid and water softening salt by pressing on it lightly. A "click" individually. will be heard when the lid is closed. Information about suitable places In programmes with prewash and (detergent dispenser, basket etc.) at high temperature, in which you in the dishwasher to place the use tablet detergents, make sure...
Rinse aid The rinse aid used in dishwashers is a special combination used to increase drying efficiency and prevent water or limescale stains 1013_redaksiyon on the washed items. For this reason, care must be paid to have rinse aid in the rinse aid reservoir and to use rinse aids produced specially for dishwashers only.
Page 17
time. We strongly recommend you to check if the tableware you are going to purchase is suitable for washing especially in the dishwasher. Placing the dishes into the dishwasher You can use your dishwasher in the optimum way with respect to energy consumption and washing and drying performance only if you place the dishes in an orderly way.
Page 18
Suggestions for loading the dishwasher Improper Loading Of Dishware Lower basket Upper basket Improper Loading Of Dishware 17 EN...
Silverware basket Movable silverware basket (depends on the model) (depends on the model) Silverware basket is designed to wash Since the cutlery basket can be moved your dishes such as fork, spoon and (A, B), you can create a wider space etc.
Collapsable lower basket wires spaces by folding each wire individually or all of them at once. Lay the foldable (2 pieces) wires down by pressing on the latch (depends on the model) (A). The two piece foldable wires located at the lower basket of the machine are �...
Lower basket multipurpose / � height adjustable service rack � � (depends on the model) This accessory located at the lower � basket of the machine allows you � to easily wash pieces such as extra � � glasses, long ladles and bread knives. �...
Upper basket drawer the tab of the glass support piece from the upper basket wire it is hooked to. (depends on the model) Thus, you can obtain a wider space. You can easily place additional desert � spoons, small forks and knives into the basket drawer installed to the upper basket of your machine.
Collapsable upper basket of the loaded basket in up or down directions without removing it from the wires machine. (depends on the model) To bring the collapsable wires on the To raise the basket: upper basket of the machine into 1.
� 2. Repeat the same process to lower To lower the basket: the other side of the basket. 1. Press the latch on the basket adjustment mechanism (right or 3. Make sure that both sides of left) to lower the basket (B). the basket height adjustment mechanism are at the same level (down or up).
Adjusting the height of empty upper basket (depends on the model) You can adjust the height of the upper basket according to the size of the dish to be washed. Use basket rollers to change the basket height. 1. Turn the stoppers on the ends of the upper basket rails by turning them aside (A).
Keys while using the lower and upper baskets of the machine. On / Off key Tablet Detergent key It is used to turn on or off the machine. This function provides better drying In On position, the machine switches performance with the multi-purpose on with the last programme in use.
Programme selection Time Delay indicator ( ) and 1. Press On / Off key to turn on your Start / Pause indicator will light machine. continuously. Remaining time will appear on the Time Delay indicator. 2. Refer to “Table of Programme Data Programme will start automatically and Average Consumption Values”...
the estimated time to the end of the Child Lock does not lock the door programme. Start / Pause indicator of the machine. starts lighting continuously. Programme follow-up Your machine performs water You can follow-up the washing step softening depending on the hardness in which the current programme is in level of the supply water.
Rinse Aid indicator new programme following the cancellation of the programme. Check the Rinse Aid indicator on the display to see whether there is enough There might be residues of softening rinse aid in your machine detergent or rinse aid left in the or not.
End of programme End of Programme indicator will light up once the washing programme is over. 1. Press On / Off key to turn off your machine. 2. Close the tap. 3. Unplug the machine from the socket. Leave your dishes in the machine for about 15 minutes to cool down after they are washed.
Maintenance and cleaning Service life of the product extends and 1. Turn the micro filter (3) and frequently faced problems decrease if it coarse filter (2) assembly counter is cleaned at regular intervals. clockwise and pull it out from its Unplug the product and turn off the seating (A).
Cleaning the impellers 3. Press the two pawls on the coarse filter inwards and separate the Clean the impellers at least once a coarse filter from the assembly (C). week in order for the machine operates efficiently. Lower impeller Check if the holes on the lower impeller (1) are clogged.
Page 35
Upper impeller Check if the holes on the upper impeller (2) are clogged. If they are clogged, remove and clean the impeller. Turn its nut to left to remove the upper impeller (C, D). Make sure that the nut is tightened well when installing the upper impeller.
Troubleshooting Machine does not start. • Power cable is unplugged. >>> Check if the power cable is plugged in. • Fuse is blown. >>> Check the fuses in your house. • Water is cut. >>> Make sure that the water inlet tap is open. •...
Page 37
Dishes are not dry at the end of cycle • Dishes are not placed orderly in the machine. >>> Place your dishes in a way that no water will accumulate in them. • Rinse aid is not sufficient. >>> Check the rinse aid indicator and add rinse aid if necessary.
Page 38
Lime traces remain on dishes and glassware gains a misty appearance • Rinse aid is not sufficient. >>> Check the rinse aid indicator and add rinse aid if necessary. Increase the rinse aid setting if there is enough amount of rinse aid in the machine.
Page 39
Rust, discoloration or surface deterioration occurs on dishes • Salt leakage exists. >>> Salt may cause deterioration and oxidation on metal surfaces. Pay attention not to spill salt around the salt filling hole while adding salt. Make sure that the salt reservoir lid is tightly closed after finishing the filling process.
Page 40
Detergent remains in detergent dispenser. • Detergent dispenser was damp when adding detergent. >>> Make sure that the detergent dispenser is dried well prior to filling it with detergent. • Detergent is added long before the washing process. >>> Pay attention to add detergent shortly before start-up of the washing.
Page 41
A smear remains on glasses that resembles milk stain which can not be removed when wiped by hand. A bluish / rainbow appearance occurs when the glass is pointed to light. • Excessive rinse aid is used. >>>Lower rinse aid setting. Clean the spilled rinse aid when adding rinse aid.