Using The Cigarette Plug Wire Assembly - XPower 150 Owner's Manual

Using the Cigarette Plug Wire Assembly

WARNING: Fire hazard
The wires in most 12 volt sockets or power outlets are not
large enough for loads greater than 150 watts: they will
overheat and present a fire hazard.
Do not use loads greater than 150 watts with the cigarette
plug wire assembly.
Loads under 150 watts When you are going to power
loads under 150 watts, use the cigarette plug wire assembly.
To connect the inverter:
1. Remove the nuts from the DC terminals on the inverter.
2. Place the red ring connector on the inverter's red
(positive +) DC terminal, and then screw the red nut on
until it is snug. Do not over tighten.
3. Place the black ring connector on the inverter's black
(negative –) DC terminal, and then screw the black nut
on until it is snug. Do not over tighten.
CAUTION: Damage to the XPower 300
Reversing the positive and negative battery cables will
damage the inverter and will void your warranty.
Double check the wiring connections: the red connector
must be connected to the red terminal, and the black
connector must be connected to the black terminal.
4. Place the lighter plug in the vehicle's cigarette lighter
socket or a 12 volt outlet.
11