Hotel Mode - Sanyo CE42LM4WPN-NA Instruction Manual

SPECIFICA
SPECIFICA
Specification
Common specification
Power source 100~240V 60Hz
AV terminal
AV1: CENELEC Standard
Input: Composite video, RGB and audio-L/R
Output: TV-output with composite video and audio-L/R
AV2: BNC
Input: RGB, H and V / Y, Pb, Pr audio-L/R
Output: RGB, H and V / Y, Pb, Pr
AV3: BNC
Input: Composite video
Output: Composite video
Audio M.Out: CINCH L/R
HDMI Input :
PC Input
Serial port: RS232C: INput/Output
Net Organiser: POA-LN01 (optional)
When ordering these products, give the Name and Type No. to the
sales dealer.
CE42LM4WPN-NA
Contrast Ratio 800:1
Screen(inches/ cm) 42"/ 107cm
(viewing measured
diagonally)
Display Resolution 1366 X 768 (WXGA)
Viewing angles H:178°, V:178°
Dimensions (WxHxDinch) 41.34" x 25.74" x 6.37"
(WxHxDmm) 1050mm x 654mm x 162mm
Weight 88.2Lbs/40Kg
This symbol on the nameplate means the product is Listed by Underwriters Laboratories Inc. It
is designed and manufactured to meet rigid U.L. safety standards against risk of fire, casualty
and electrical hazards.
10
TIONS / HELPFUL
TIONS / HELPFUL
HDMI GROUP Standard
HINTS / HOTEL
HINTS / HOTEL
Helpful hints
■ NO PICTURE
● Check if monitor is plugged in.
● Try a different channel, if OK, probably station trouble.
■ POOR PICTURE,
● Adjust BRIGHTNESS control.
● Adjust FINE TUNING control.
● Check aerial connections.
■ NO COLOR, PICTURE OK
● Adjust COLOR control.
● Adjust FINE TUNING control.
● Is the programme in color?
■ WEAK PICTURE
● Check aerial connections on back of set.
● Check aerial for broken wires.
● Re-orient aerial.
The following faults are not caused by the receiver:
"GHOSTS"
Reflections of signals from mountains or high buildings will cause
multiple images, called "Ghosts". These abnormal conditions can be
reduced to a minimum by repositioning aerial or by installing a new
one suited for your area.
"INTERFERENCE"
Interference may be caused by electrical appliances, car ignition
systems, etc. This should normally be a temporary condition, but
should this interference persist, contact your dealer.

Hotel Mode

This LCD monitor set allows you to set up the following:
SETTING PROCEDURE:
1 . Press and hold the green button on the Remote control
handset and then press the 5 button on the Monitor for 5
seconds.
2. Use the 5 or 6 button to highlight Hotel Mode, use the 1
to switch ON or OFF.
Hotel
Hotel mode ON / OFF
On program OFF/ 1~99
Preset ON / OFF
Address 007
Baud Rate 19200
: Select
Select ON program using the 6 button, select the start up posi-
3.
tion using the 1 or 2 buttons.
(AV2 - AV1 - 0 - 1 - 2 - 3 - 4 ........99)
4. Press the MENU button to exit from the menu.
MODE
MODE
/ AV1-AV3 /RGB/ HDMI/ PC
: Adjust : Exit
MENU