Do you have a question about the TX and is the answer not in the manual?
Questions and answers
Blanche Laurie-Chiswell
March 31, 2025
How to load the bobbin
1 comments:
Mr. Anderson
March 31, 2025
To load the bobbin on an ELNA TX sewing machine:
1. Put a drop of oil in the rotary hook at the marked red point. 2. Raise the thread guide under the accessory case cover. 3. Disengage the flywheel by unscrewing the coupling knob. 4. Pull out the spool pin and place the thread spool on it. 5. Place the bobbin on the bobbin winder with the holed side up. 6. Pass the thread through the raised thread guide. 7. Wind the thread end around the bobbin by hand in the indicated direction. 8. Push the bobbin winder to the right. 9. Press lightly on the spool with a finger while winding to stretch the thread. 10. When full, the bobbin stops automatically. 11. Re-engage the flywheel by tightening the coupling knob.
Need help?
Do you have a question about the TX and is the answer not in the manual?
Questions and answers
How to load the bobbin
To load the bobbin on an ELNA TX sewing machine:
1. Put a drop of oil in the rotary hook at the marked red point.
2. Raise the thread guide under the accessory case cover.
3. Disengage the flywheel by unscrewing the coupling knob.
4. Pull out the spool pin and place the thread spool on it.
5. Place the bobbin on the bobbin winder with the holed side up.
6. Pass the thread through the raised thread guide.
7. Wind the thread end around the bobbin by hand in the indicated direction.
8. Push the bobbin winder to the right.
9. Press lightly on the spool with a finger while winding to stretch the thread.
10. When full, the bobbin stops automatically.
11. Re-engage the flywheel by tightening the coupling knob.
This answer is automatically generated