Page 1
MR850 professional MR850 Rolling Garage Door Opener Installation and Operating Instructions Owners Copy: Please keep these instructions for future reference This manual contains IMPORTANT SAFETY information DO NOT PROCEED WITH THE INSTALLATION BEFORE READING THOROUGHLY...
START BY READING THESE IMPORTANT SAFETY INSTRUCTIONS WARNING • Failure to comply with the following instructions may result in serious personal injury or property damage. • Read and follow all instructions carefully. • The garage door opener is designed and tested to offer safe service provided it is installed and operated in strict accordance with the instructions in this manual.
TESTING THE DOOR Complete the following test to ensure your door is well balanced, and not sticking or binding: • Disable all locks and remove any ropes connected to the garage door. • Lift the door to about halfway and then release it. The door should remain spring balanced.
THE RELEASE HANDLE & CORD • Thread one end of the rope through the hole in the top www.chamberlainanz.com MR850 of the red release handle so that “NOTICE” reads right side up as shown. • Secure with an overhand knot at least 25mm from the professional end of the rope to prevent slipping.
Page 6
ATTACHING EXTENSION POLES (IF REQUIRED) Optional accessory not provided • Align the extension pole holes with the drive legs. • Insert the extension poles into the drive leg and fix in place using screws provided. • Slide the reinforcing brace over the poles and fix in place using the screws provided.
INSTALLATION PROCEDURE Do not allow people to walk under or around the door during the installation process as serious injury can occur. NOTE: The opener can be installed on either side of the door. The following instructions are for Rope RIGHT HAND INSTALLATIONS (as illustrated i.e.
NOTE: The MR850 opener is factory configured for right hand installation. The opener will operate during this procedure. Make sure the door is clear of obstruction.
SETTING THE FORCE The force, as measured on the closing edge of the door, should not exceed 400N (40kgf). If the closing force is Press twice professional measured to more than 400N, the Protector System FLASHING Beams) must be installed (refer section 17). orange LED •...
INSTALL THE PROTECTOR SYSTEM™ (IR BEAMS) NOTE: This accessory must be used for all installations where the closing force as measured on the bottom of the door is over 400N (40kgf). After the opener has been installed and adjusted, the Protector System™...
LRN Press LRN • The courtesy LEDs will flash once. • Ensure the door is clear of obstruction, then test the remote. www.chamberlainanz.com MR850 Release LRN button when Deleting ALL remote control codes professional Courtesy LEDs flashes once NOTE: This deletes all remotes and codes •...
KEYLESS DEVICE PROGRAMMING (OPTIONAL ACCESSORIES ) p ro fe s s io n a l Activate the opener only when the door is in full view, free of obstruction and properly adjusted. No one should enter or leave garage whilst the door is in motion. Do not allow children to operate push button(s) or remote(s).
SPECIAL FEATURES (OPTIONAL ACCESSORIES) 1. Solenoid roller door lock (SRDLK01) 2. 24VDC power output for external devices 3. Voltage free door monitoring output 4. The Protector System (C77 IR Beams) 5. Multi-function wall control (C98) 6. Standby Power Unit (battery backup C475) 7.
041A6812 in order to avoid hazard. 041A6813 041D6637 001A6528 041A6815 041A6814 041A6778 001B6681 041A6811 Mount plate sub assembly MR850 (including motor) 041A6812 Sungear kit MR850 041A6813 Front upper housing MR850 041A6814 Base housing MR850 041D6637 PCB for MR850 041A6778 Removable cover sub assembly...
ACCESSORIES 8. Model C379 Wireless finger print access system 1. Model CM128 2 Channel wireless wall button 9. Model C98 Motion detecting control panel 2. Model CM842 2 Channel remote control 10. Model 760 Outside keyswitch 3. Model CM844 4 Channel remote control 11.
• Turn the power off and remove the SPU if installed. Over current • Turn power back on and plug the SPU back in if installed. If opener fails to operate correctly after resetting contact your Chamberlain Merlin Professional Dealer. Symptom: Opener will not open or close the door 10 to 15 FLASHES •...
TROUBLESHOOTING • Repeat the limit and force setting in section 13 &14. Repeat safety reverse test after adjustments. 1. The opener will not operate from either the 9. The opener strains to operate door: ACTIVATION button or the remote controls: •...
Zealand Limited (Seller) warrants to the original from breach of law or contract or for negligence, exceed the purchaser of the Chamberlain Merlin MR850 Roller Door cost of repairing or replacing the Unit or refunding the Opener (Unit) that it is free from defects in material purchase price of the Unit.
Need help?
Do you have a question about the Merlin MR850 and is the answer not in the manual?
Questions and answers