Reset To Factory Defaults - THOMSON SpeedTouch 585 Installation And Setup Manual

Chapter 4
Troubleshooting
Resetting your
SpeedTouch™
Reset to default
configuration
38

4.7 Reset to Factory Defaults

You might consider a reset to factory defaults as described below.
Be aware that a reset to factory defaults will revoke all configurational
!
changes you made to the SpeedTouch™.
A reset to factory default settings deletes the configuration profile settings.
Therefore, after the reset, a reconfiguration of your SpeedTouch™ will be needed.
Proceed as follows:
1
Make sure the SpeedTouch™ is turned on.
2
Use a pen or an unfolded paperclip to push the recessed reset button on the
back panel. The reset button is marked with a red circle. Push it until the power
LED lights red - this will take about 7 seconds.
ON/OFF
3
Release the reset button.
4
The SpeedTouch™ restarts.
1 2 3
2
1
Reset Ethernet
E-DOC-CTC-20051017-0093 v1.0
4
3
4
DSL