Installation; Setup - Aurora ASP-FIBRS2 User Manual

INSTALLATION

Setup

1. Connect your HDMI source to the HDMI input connector on ASP-FIBRS2-TX side.
2. Connect your HDMI display to the HDMI output connector on ASP-FIBRS2-RX side.
3. Plug the fiber to both TX and RX SC Duplex fiber connectors.
4. If serial control is required, connect the serial cabling at each end.
5. Power up your HDMI source, display and the ASP-FIBRS2.
6. When connection is built, the Data Indicator will blink rapidly and video will be shown on
the display side.
7. RS232 baud rate setup:
The default baud rate for RS232 connection is 9600. To change the baud rate, follow the
steps below: Keep in mind if the unit has been set to a different baud rate you will need to try
the various baud rates until the unit responds.
a) Power off Rx / Tx
b) Connect Rx and Tx together via Fiber.
c) Connect PC to Rx RS-232 Port (via Null Cable)
d) Setup PC terminal program at 9600-N-8-1 (Default Baud, or other as applicable if
different)
e) Power up Rx and Tx.
f) Immediately send multiple [CNTL + C] when first applying power to the receiver unit. If
there is no response after 5 sec then the unit is set to a different baud rate (Or send 0x03
via Hercules: $03)
g) You will see message regarding "Pressing Enter for 115200".
h) Change terminal program to 115200-N-8-1.
i) Send new baud using the command: soip 0 x y (x = 2400 – 115200) (y = 2400-115200)
j) Now reboot the unit. They will now be at the new baud rate.
3
User Guide