Connection Via A Redundant Network - Yamaha AIC128-D Operation Manual

Connection via a Redundant Network

Dante redundancy works by using two completely
independent and separate networks, the Primary Network and
the Secondary Network.
To set up and use Dante Redundancy, connect your redundant
Dante-enabled device using duplicate network switches and
Ethernet cables as shown below.
Connect the following to the Primary Network only:
• Any computers running Dante Controller
• Any non-redundant Dante-enabled devices
All Dante-enabled devices that support redundancy should be
connected to both the Primary and Secondary networks.
The primary and secondary networks MUST NOT be
interconnected at any point.
Primary network
Network switch 1
Dante-enabled device
Without redundancy support
1.
Make sure all computers are set to automatically
configure their IP address.
2.
Power on the network switch.
3.
Connect your Primary Ethernet cables from each
device to the Gigabit ports of the Primary network
network switch.
Ethernet network
Dante Controller
adapter
Dante
Accelerator
Primary Secondary
port port
Dante-enabled device
With redundancy support
Primary Secondary
port
port
Secondary
Primary
port
port
DANTE ACCELERATOR Operation Manual
Connecting to a Network
Secondary network
Network switch 2
6