Create A Room; Setting A Secondary Controller - Honeywell Tuxedo Touch Series Installation And Setup Manual

Create a Room

Multiple devices can function as a group by associating them in a "Room". Follow the procedure below to
create a Room.
ICON
1. Press the Automation icon and then
press the Room Setup icon.
2. Press the Add icon and enter a room
name on the "Data Entry" keyboard.
3. Press OK.
4. Highlight the device(s) from the list
that you want to add to this Room
and press the Save icon.
Room Setup Icons
Delete
Edit

Setting a Secondary Controller

After all Z-Wave devices have been included into the Primary Controller, the device information on the
Primary Controller can be downloaded to a Secondary Controller. Apply power to the Secondary
Controller and do the following:
ICON
1. On the Primary Controller:
a) Press the Automation icon from
the "Home" screen and then press
the Z-Wave Setup icon to display
the "Z-Wave Device
Management" screen.
2. At the Secondary Controller:
a) Remove any Z-Wave devices that
have been added.
b) Press the Z-Wave Primary icon
(located in the lower right side of
the screen).
c) Select Yes to change this keypad
to a Secondary Controller.
3. At the Primary Controller:
a) Press Add.
4. At the Secondary Controller:
a) Press Add.
Automation (cont'd)
ACTION
Add Save
ACTION
35
NOTES
Room names (i.e., All, etc.) are displayed across
the top to the screen.
Enter the new device name by entering it on the
data entry keyboard.
• Use the Shift icon for capital letters.
• Use the BS (Backspace) icon to make
corrections.
The @#$ icon is not available for use at this time.
Use the Edit and Delete icon to rename, or delete a
room.
NOTES
The message is displayed:
"Please remove all Z-wave devices from network
first"
The message is displayed: "Scanning for Devices"
The message is displayed: "Updating Devices.
Please Wait".
When the device information from the Primary
Controller is downloaded to the Secondary Controller:
• the Secondary Controller displays, "Controller Add
Success".
• the Primary Controller displays, "Device Added
Successfully".