7. Removal of the roller holder
(1) Remove the two Retaining Rings (E-Type) for D3 Shaft [52] from the Pin [42].
(2) Pull out the Needle Roller [40] press-fitted in the Gear Holder [35] and remove the Roller Holder [41].
(3) Remove the Needle Roller [40] from the Gear Holder [35].
• Removal of the roller holder
Retaining Ring (E-Type) for D3 Shaft [52]
8. Removal of the change knob
(1) Remove the Retaining Ring (E-Type) for D5 Shaft [36] and remove the Change Knob [45], Spring (C)
[46] and Steel Ball D3.97 [47].
(2) Be careful not to lose Spring (C) [46] and the Steel Ball D3.97 [47].
• Removal of the change knob
Change Knob [45]
Needle Roller [40]
Roller Holder [41]
Pin [42]
Steel Ball D3.97 [47]
Spring (C) [46]
Retaining Ring (E-Type)
for D5 Shaft [36]
-15-
Gear Holder [35]