Mem Card (Mem3 Or Mem4): Only Use In The Idcs 100 System; Figure 3.9 Mem3 Card; Figure 3.10 Mem4 Card - Samsung OfficeServ 100 Installation Manual

3.12 MEM Card (MEM3 or MEM4): only use in the
iDCS 100 system
Select the appropriate of MEM for the system. Make sure that back up switch is OFF
position. Insert the MEM card in the KSU slot labeled MEM. Push in middle of the MEM
card(MEM3 or MEM4) to ensure that it is fully inserted into the back plane connector.
To prevent accidental damage to MEM card, the connector on the back plane is positioned
to mate only with the MEM card. Other interface cards will not mate with this connector
and MEM card will not mate with any other connector.
MEM3 card has EPROM memory to support new features Window PC-MMC, ITM3 &
TEPRI cards. MEM4 card with LAN interface module, no selectable options. The LAN
module is required to expand the system memory, to provide SIO ports 1EA, and a 10/100
BASE-T LAN interface processor. MEM4 card has Flash memory to support new features
Window PC-MMC, ITM3, TEPRI cards and Networking solution by TEPRI,
Program/Database up/down-load by LAN interface.

Figure 3.9 MEM3 Card

© SAMSUNG Electronics Co., Ltd.
OfficeServ 100 Installation Manual/Ed.00

Figure 3.10 MEM4 Card

3-11