Table of Contents
Advertisement
ELECTRICAL COMPONENTS
3.
Return electronics module to its original location and secure with bolt (11) (Figure 17-8, Page 17-11). Tighten
bolt to 40 in-lb (4.5 N·m).
4.
Place the Tow/Run switch in the TOW position and connect the batteries. See Connecting the Batteries –
Electric Vehicles on page 1-3.
1
709
Figure 17-6 Tow/Run Switch
THROTTLE POSITION SENSOR (TPS)
See General Warnings on page 1-1.
TESTING THE THROTTLE POSITION SENSOR
See Test Procedure 4 – MCOR Voltage on page 12-16 and Test Procedure 8 – Key Switch and MCOR Limit
Switch Circuit on page 12-21.
See Test Procedure 4 – MCOR Voltage on page 14-16 and Test Procedure 8 – Key Switch and MCOR Limit
Switch Circuit on page 14-20.
THROTTLE POSITION SENSOR REPLACEMENT
The throttle position sensor itself is not intended to be replaced. If sensor is determined to need replacing through
test procedures listed above, the accelerator pedal assembly must be replaced. See Accelerator Pedal Removal
on page 5-6.
3
2
4
2009-2011 Electric Precedent Maintenance and Service Manual
Throttle Position Sensor (TPS)
17
Page 17-7
- Quick Links:
- Wiring Diagrams
- Speed Setting
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the 2009-20011 Electric Precedent and is the answer not in the manual?
Questions and answers
How do you find the wattage on a 2011 48 volt club car prescedent
To find the wattage on a 2011 Club Car Precedent 48-volt vehicle, you can multiply the system voltage by the current drawn by the motor. The formula is:
Wattage (W) = Voltage (V) × Current (A)
The system operates at 48 volts DC. To determine the current, you need to measure it while the vehicle is operating using an ammeter or obtain it from the vehicle diagnostics if available. Once you have both values, apply the formula to calculate the wattage.
This answer is automatically generated