WAVELENGTH: 654 - 662 nm LASER OF CLASS 2. LASER DIODE CHARACTERISTICS SERVICING OPERATION OF THE APPARATUS MAXIMUM OUTPUT POWER: 36 mW SHOULD DONE SPECIALLY WAVELENGTH: 780 - 787 nm INSTRUCTED PERSON. • KBXV type (DRW2233) • BXV/CN type Bottom (DRW2235) DVR-S806...
Page 3
To protect products from damages or failures during transit, the shipping mode should be set or the shipping screws should be installed before shipment. Please be sure to follow this method especially if it is specified in this manual. DVR-S806...
3.1.1 EMERGENCY DISC REMOVAL......................11 3.1.2 DISASSMBLY ............................ 11 3.1.3 PICKUP LENS CLEANING ....................... 12 3.1.4 Failure Test (Diagnosis) Method ......................14 3.1.5 How to Write the GUID ........................17 3.1.6 How to Check and Update the Version of the Firmware ..............21 DVR-S806...
IEEE 1394 cable (1.5 m) ......... 2 Manual eject pin ..........1 Vertical stand ........... 2 Operating instructions ........1 Manual eject pin ..........1 Operating instructions ........1 NOTE: • Specifications and design subject to possible modifications without notice, due to improvements. DVR-S806...
Therefore, when replacing, be sure to use parts of identical designation. Screws adjacent to mark on product are used for disassembly. For the applying amount of lubricants or glue, follow the instructions in this manual. 2.1 PACKING BXV/CN type only DVR-S806 x3 set DVR-S806...
Page 7
NSP 8 Polly Bag DHL1119 Pad F806 DHA1648 Pad R806 DHA1649 (2) CONTRAST TABLE DVR-S806/KBXV and DVR-S806/BXV/CN are constructed the same except for the following : DVR-S806 DVR-S806 Mark No. Symbol and Description KBXV BXV/CN > 1 AC Power Cord...
2.2 EXTERIOR SECTION Rear view Refer to "2.3 DVD/CD Drive Section". Power Connector Section. Bottom DVR-S806...
Page 9
Case Assy + Option DXA2020 Screw IMZ30P050FMC Gaskets B DEB1632 Screw PMZ30P060FMC (2) CONTRAST TABLE DVR-S806/KBXV and DVR-S806/BXV/CN are constructed the same except for the following : DVR-S806 DVR-S806 Mark No. Symbol and Description KBXV BXV/CN > 12 Case Assy...
2.3 DVD/CD DRIVE SECTION Screw Screw UP case Low case [ Back side] [ Back side] Screw DVD/CD DRIVE SECTION parts List Mark No. Description Part No. Mark No. Description Part No. DVR-S806...
It is an upper case to rear . (about 10mm) It is made to slide. Cover Block (Lock release is carried out) Upper case Front upper case is removed upwards. Mark (right and left) Lock release Upper case Remove the Shield case DVR-S806...
Position to be cleaned Cleaning tools Pickup leneses Cleaning liquid : GEM1004 Cleaning paper : GED-008 Cover Remove the Cover Tray open [Back side] Eject hole Hook Hook Hook Hook Push Push rod DVR-S806...
Page 13
Remove the Low Case Remove the Clamper Holder Front Bezel Cleaning liquid (GEM1004) Hook Cleaning paper (GED-008) Remove the Front Bezel Hook DANGER - LASER RADIATION WHEN OPEN. AVOID DIRECT EXPOSURE TO BEAM. UP Case Remove the UP Case DVR-S806...
• Procedures 1. Start up your PC. 2. Turn the DVR-S806 on. 3. Connect the PC and the DVR-S806 using a USB 2.0 cable. 4. Double-click on the icon for the copied "S806ca.exe" program. 5. Program execution begins. • Startup screen Select PIONEER DVD-RW DVR-108.
Page 15
Click on "3. DVDT-RW write" shown on the test screen below, and the test will start. If the result is OK, " " will be displayed in the space "Judge." Whether or not any errors are generated during writing and verifying is checked. • Test screen 2. DVDT-001 TransferRate 3. DVD-RW write Judge DVR-S806...
Page 16
5 : DVD Full-Seek 210 (ms) 6 : DVD Random-Access 3.30E-03 7 : DUAL ErrRate L0 In 3.30E-03 8 : DUAL ErrRate L1 Out 240 (ms) 9 : DUAL Random-Access 3.30E-03 A : DVD-R Write 3.30E-03 B : DVD-RW Write [ESC] x2 DVR-S806...
• The program for writing the GUID will run only on Windows 2000 or Windows XP when the DVR-S806 is connected with it via a USB interface.
Page 18
2. Select the program for writing the GUID, and double-click on the "StorageEe Writer.exe" (2). 3. When ERROR window is displayed, click on the "OK" (3). 4. Startup screen of "StorageEe Writer.exe" Pioneer settings Initial settings in the chip DVR-S806...
Page 19
5. Click on the "Read" button (4), the EEPROM data of the drive will be read-out. DHTO004857WL 5. Click on the "Load" button (5), and select the transmit data. PL3507_69_KBXV.sdt PL3507_70_J.sdt PL3507_71_BXVCN.sdt PL3507_69_KBXV.sdt : DVR-S806/KBXV PL3507_70_J.sdt : DVR-S806-J PL3507_71_BXVCN.sdt : DVR-S806/BXV/CN PL3507_69_KBXV.sdt "PL3507_69_KBXV.sdt" in case of DVR-S806/KBXV DHTO004857WL DVR-S806...
Page 20
In this case, enter "12F9." If the leftmost digit of the converted value is 0, such as "0401" in hexadecimal conversion for "1025" in decimal, omit that zero and just enter "401." 8. Once you click on the "Write button" (6), the GUID will be written. 12F9 DHTO004857WL DHTO004857WL DVR-S806...
Program disc for updating the firmware (GGS1052 (2/2)) : " rw-pl3507: ROM Writer 2.1.1 RS32.exe " • Startup screen 1. Use Windows 2000 or Windows XP as the OS. And double-click on the " rw-pl3507 " folder (1). 2. Double-click on the program for updating the firmware " ROM Writer2.1.1 RS32.exe " (2) . DVR-S806...
Page 22
• If "Finished read (Save As. . .)" is displayed, click on " OK" (4). If the displayed version number is 2004.08.06.149, it is the latest version (as of September 2004.) Terminate the program. Note: The version of the firmware can be updated. • If "Save As" is displayed, click on "Cancel" (5). DVR-S806...
Page 23
4. Updating the version of the firmware • Click on " Load File... " (6), and select " PL3507-0310B-pioneer.hex " (7) Then click on "Update " (8) Note: Do NOT forcibly terminate the program before writing is finished. If you do, the file in the EEPROM will be destroyed and cannot be restored.