Snmp Settings - Motorola Netopia 2200 Series User Manual

CONFIG Commands

SNMP Settings

The Simple Network Management Protocol (SNMP) lets a network administrator monitor
problems on a network by retrieving settings on remote network devices. The network
administrator typically runs an SNMP management station program on a local host to
obtain information from an SNMP agent such as the Motorola Netopia® Gateway.
set snmp community read name
Adds the specified name to the list of communities associated with the Motorola Netopia®
Gateway. By default, the Motorola Netopia® Gateway is associated with the public commu-
nity.
set snmp community write name
Adds the specified name to the list of communities associated with the Motorola Netopia®
Gateway.
set snmp community trap name
Adds the specified name to the list of communities associated with the Motorola Netopia®
Gateway.
set snmp trap ip-traps ip-address
Identifies the destination for SNMP trap messages. The ip-address argument is the IP
address of the host acting as an SNMP console.
set snmp sysgroup contact contact_info
Identifies the system contact, such as the name, phone number, beeper number, or email
address of the person responsible for the Motorola Netopia® Gateway. You can enter up to
255 characters for the contact_info argument. You must put the contact_info argu-
ment in double-quotes if it contains embedded spaces.
set snmp sysgroup location location_info
Identifies the location, such as the building, floor, or room number, of the Motorola Neto-
pia® Gateway. You can enter up to 255 characters for the location_info argument.
265