Main menu
Fig. 7 Information display: Control elements on the windshield wiper lever/
control elements on the multifunction steering wheel
ä
First read and observe the introductory information and safety warn-
ings
on page 18.
Operating with the buttons on the windshield wiper lever
›
You can activate the Main menu by pressing the rocker switch
more than 1 second.
›
Individual menu points can be selected by means of the rocker switch
the pushbutton
is briefly pressed, the information you have selected is dis-
B
played.
Operating with the buttons on the multifunction steering wheel
›
You can activate the Main menu by pressing the rocker switch
more than 1 second.
›
By briefly pressing the
button you will reach one level higher.
C
›
The individual menus can be selected by pressing the adjustment wheel
The selected menu is displayed after briefly pressing the adjustment wheel
The following information can be selected (depending on the equipment installed
on the vehicle):
MFD
» page 14
■
■
Audio
Navigation
■
Phone
» page 119
■
■
Aux. Heating
» page 93
Assistants
» page 46
■
Vehicle status
» page 21
■
■
Settings
» page 19
The menu points Audio and Navigation are only displayed when the factory-fitted
radio or navigation system is switched on.
The menu point Aux. heating is only displayed if a factory-fitted auxiliary heating
is installed.
The menu point Assistants is only then displayed, if the vehicle is fitted with cor-
nering lights.
Note
If warning messages are shown in the information display, these messages
■
must be confirmed with the button
button
on the multifunction steering wheel to call up the main menu.
D
If the information display is not activated at that moment, the menu always
■
shifts to one of the higher levels after approx. 10 seconds.
The operation of the factory-fitted radio or navigation system is described in
■
separate operating instructions to be found in the on-board literature.
Settings
» Fig. 7
for
A
ä
First read and observe the introductory information and safety warn-
ings
. When
A
You can change certain settings by means of the information display. The current
setting is shown on the information display in the respective menu at the top be-
low the line.
» Fig. 7
for
C
The following information can be selected (depending on the equipment installed
on the vehicle):
Language
■
.
D
■
MFD Data
.
D
Convenience
■
Lights & Vision
■
Time
■
Winter tyres
■
Units
■
Assistants
■
■
Alternative speed displayed
Service
■
Factory setting
■
■
Back
on the windshield wiper lever or with the
B
on page 18.
Instruments and warning lights
£
19
Need help?
Do you have a question about the Yeti and is the answer not in the manual?
Questions and answers