Motor; Tonearm - Pioneer PL-L1000 Service Manual

t
3.2 D.D MOTOR
1. Remove the 3 D.D motor securing screws.
2. Disconnect the D.D motor connector.
3.3 TONEARM
1. Remove the plate pressing against the tone-
arm output cable.
2. Remove the coil & rail ass'y.
3. Disconnect the ground lead connected to
the front rail from P.C.B.
4. Remove the E-type washers and screw holding
the gear and rail of the elevation mechanism.
The front rail may then be removed by pulling
E-type
washer
G r o u n d l e a d
FL-LI
Oclcl
Fis. 3-2
out towards the right.
5. The other rail may also be removed by pull-
ing out to the right after loosening the securing
screw.
6. The tonearm may be removed once both rails
have been pulled across to the right by at
least 15cm.
C o i l & R a i l a s s ' y
)
l"
a
E
!t
F i g . 3 - 3
F i g . 3 - 4