Safety Equipment - Husqvarna 181 Workshop Manual

Safety Equipment
11.
A. Chain brake
R
Remove the clutch cover and clean brake mechanism and brake band.
Fix the brake in the clamping device No. 5025102-01 and remove the Swed-o-
Matic adjusting screw.
Release the brake.
Remove the screw from the front support of the hand guard by means of
Allen key No. 5025019-01. Remove the two sleeves with a screw driver.
Loosen the nut (M) and lift off the hand guard.
When dismantling the brake band use a drift @ 4 mm to push out the roll pin.
The catch may be changed after pushing out the roll pin with a drift @ 4 mm.
Check the wear on the locking part of the catch (see A).
-
'
..
37