Assembly Instructions - SOLE F80 Owner's Manual

ASSEMBLY INSTRUCTIONS

1
ASSEMBLY STEP 1
1. Remove the treadmill from the carton and position it aside on a smooth,
level floor. The rear should be at least 3' from any wall. Do not remove the
Velcro belt until you have removed the plastic wrap and Styrofoam from
beneath the unit. Turning the unit on its side after removing the belt
may cause the unit fold up and cause serious injury!
2
ASSEMBLY STEP 2
1. Install the six Speed Nut Clips (128) on the Frame Base left and right side.
2. Slide the lower handlebar covers (65 & 67R) onto the console masts
(notice orientation).
3. Slide the Frame Base Caps (161 L & 162 R) over the Upright tubes (4
& 5). Connect the Lower Computer Cable (49) to the Middle Computer
Cable (50) on the right side of the unit.
Before attaching the hardware to Step 3, make sure the cables you just
connected don't get pinched in between the steel tubing. If they do, this may
cause issues that prevent the treadmill from operating properly.
8
HARDWARE STEP 2
#128. M5 Speed Nut
Clip (6 pcs)