Setting The Time And Date - ADC 6014 Instruction Manual

User selections
This advanced blood pressure monitor allows you to track blood pressure
readings for 2 individuals independently.
a) Before taking your measurement, make sure you set the unit for the
intended user. (User 1, User 2)
b) The unit is preset to User 1. Press and hold the USER/TIME button until
you see the user icon blinks, then press the memory button to select the
user1 or user 2, and then press the Time button again to confirm
c) Press the USER/TIME button again to change back to User 1.
d) After you have selected a User, wait 3 seconds and the display will stop
blinking. The User is now selected.
Note: Before proceeding make sure the unit is turned on.
5.4. Measurement mode selection
Clinical studies demonstrate taking multiple blood pressure
readings and calculating an "average" is more likely to determine your
true blood pressure. Your ADC ® unit allows you to switch it into an
Average Mode setting that automatically takes multiple readings!
Average mode slide switch:
a) If you would like to take an average mode
measurement, move the slide switch to the right.
b) Average mode takes 3 measurements in
succession and calculates the result. An "MAM"
symbol in the display indicates that the unit is
set to the average mode.
c) There will be 15 seconds resting time in-between each
measurement and an hourglass icon will appear on the display.
The unit will count down from 15 seconds. A beep will sound at
the last 5 seconds to remind you that the unit is about to take
another measurement.
Single mode
a) If you would like to take a single mode measurement,
move the slide switch to the left.
b) Single mode only has 1 measurement.
11
User Selection
1 2 2
User 1 symbol User 2 symbol

4.5. Setting the time and date

This blood pressure monitor incorporates an integrated clock with date display. Time and date are
recorded along with pressure and pulse. You must enter the date and current time. Proceed as follows
(Example: Entering 2002-06-15, 09:30 AM): Turn on unit.
1. Press and hold the USER/TIME button for at
least 3 seconds, the user icon will blink, after set-
ting the user, the year characters will blink then.
2. The correct year can be entered by pressing the
MEMORY button once for each change.
(Example: 1 press for 1 year)
3. Press the USER/TIME button again. The display
now switches to the current date, during which the
first character (month) blinks. Note: Holding the
"M" button down speeds up the procedure.
4. The current month can now be entered by
pressing the MEMORY button. (Example: pressing
5 x advances 5 months)
5. Press the USER/TIME button again. The last
two characters (day) are now blinking.
6. The current day can now be entered by pressing
the MEMORY button. (Example: 14 presses
advances the day from the 1st to 15th)
7. Press the USER/TIME button again. The display
now switches to the current time, during which the
first character (hour) blinks.
TIME
8. The corresponding hour can now be entered
by pressing the MEMORY button.
(Example: 9 presses advances 9 hours)
TIME
8