Miele G 605 Operating Instructions Manual page 53

Measure the distance from the ad-
jacent cabinet (or appliance) door
bottom to the bottom of of the mount-
ing bracket (X).
Using measurement (X), draw a line
on the rear of the door panel (X) in-
ches up from the bottom.
Remove the bracket from the ma-
chine door and place it on the rear of
the door panel.
a) Center the bracket left to right,
and
b) align the bottom of the bracket
with the (X) line.
Proceed to the step after next begin-
ning with "Tape the bracket..."
Place the bracket on the back of the
door panel and adjust it so that:
– the lines you drew on the templates
align with the upper edge of the door
panel and;
– the mounting bracket is centered
(left to right) on the door panel.
Tape the bracket to the door panel to
hold it in place while the mounting
holes are being drilled.
Dishwasher installation
Drill pilot holes for the screws using a
3/32" (2.5 mm) bit.
Attach the bracket to the panel using
the 6 screws provided.
Remove the templates.
The templates should be kept in case
you want to install a different door
panel on the dishwasher at a later date.
Attach the panel to the dishwasher
by aligning the bracket tabs with the
slots on the door.
53