Quick Start - Goclever DVR LITE Owner's Manual

Quick Start

1. Take the device out from the box and check for the following accessories:

Car Video Camera DVR HD (1 pc)

Car Battery Charger (1 pc)

USB/mini USB cable (1 pc)

Windshield holder (1 pc)

BL - 4C Battery (1 pc)
2. Place the battery in the device by removing the battery cover (see page 26, sec. 8)
3. Plug the unit via the car charger. While charging the LED (see page 26, sec. 12) should
turn red. The unit should be recharged for about 6 hours. Blue LED light indicates fully
charged batteries. The device can be plugged in during the recording.
4. Put the SD memory card in memory card slot (see page 26, sec. 4). Note: memory card
not included! You must obtain a SD or MMC card up to 32GB.
5. Open the LCD and turn on the device by holding the power button (see page 26, sec. 11)
for three seconds.
6. The device is now working. You should see a welcome screen and hear a beep sound.
7. Install the unit on the windshield of the vehicle on its inner side with the included device
holder. Fix the holder (see page 26, sec. 19) into the fixing hole (see page 26, sec. 6.)
8. Remove the secure foil from the cup holder (see page 26, sec. 21). Lift the lever on the
suction cup (see page 26, sec. 18). Place the suction cup to the on the windshield and
close the lever. Make sure the camera is mounted securely.
9. Use the knobs on the device holder to adjust the camera position, so that the camera lens
(see page 26, sec. 9) was directed to the windshield. LCD (see page 26, sec. 13) should
be pointed towards the driver.
10. Your device is ready to work!
27