Voice Response Mode; Customization / Other Functions; Voice Prompts Level; Normal And Loud Modes - Fugoo FSNA1 User Manual

Voice Response mode

• While your phone or other device is paired to the speaker (and a call is not in
progress) hold  (Action) for one second. A tone sounds through the speaker to
activate a voice response service, such as Siri or Google Now.
• Speak voice response commands through the speaker's microphone.
• Click + or –
• Click the  (Action) button) to cancel voice response mode.

Customization / other functions

Normal and Loud modes

• There are two EQ modes for your Fugoo Bluetooth Speaker.
default, and is designed for best overall sound with most types of music.
is significantly louder, and is optimized for playing music outdoors, and in large
rooms. Both modes employ dynamic realtime equalization to boost the loudness of
songs that have been recorded at lower volume levels.
• To switch from one mode to the other, start with the speaker off, then press and hold
the Action (O) button and press the power button. The speaker will turn on, and
announce which mode it's in.

Voice prompts level

• There are three voice prompt levels: Normal, Low and Off. Normal is the factory
default volume level – the level for voice prompts you will hear when you first turn on
your Fugoo Bluetooth Speaker. The Low level is about 20% lower than the Normal
level.
• To change the voice prompt level from Normal to Low, start with the speaker off,
then press and hold the
press the
that voice prompts have been set to Low.
• Follow the same steps as above to change the voice prompt level from Low to Off.
• Follow the same steps again to change the voice prompt level from Off to Normal.

Power Save On / Off

The speaker can shut itself off to conserve power, after a period of inactivity. Beginning
with firmware version 1.0.43, the Power Save feature can be toggled on and off by
holding the – (volume down) button while turning the speaker on with the
button.
If Power Save is on, then the speaker will shut itself off as follows...

If the speaker is
and is not

If the speaker is
and is charging,
User Manual Fugoo Bluetooth Speaker model FSNA1
to raise or lower the volume.
–
(volume down) and
(Power) button for one second. The speaker will turn on, and announce
not connected to a source device
charging, the speaker turns off after 15 minutes of inactivity.
not connected to a source device
the speaker turns off after 30 minutes of inactivity.
Normal mode
+
(volume up) buttons, then also
page 8
is the
Loud mode
(Power)
9/25/2014